BROSA Junior Kids Wardrobe User manual

ASSEMBLY GUIDE
Junior Kids Wardrobe
v1.0

A x 16
(Cam Screw)
B x 16
(Cam Lock)
C x 50
(Short Screw)
(M3.5 x 16)
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
D x 6
(Hinge)
E x 12
(Long Screw)
(M3.5 x 18)
What you need
Left Door
Right Door
Base Panel x 1
Hang Rail x 1
Leg x 4
Left Side x 1
Right Side x 1
Shelf x 1
Top Panel x 1
Back Panel x 1
Components
1
2
3
4
5
6
7
8
9
Hardware

Step 1 Align a leg to the underside of the base corner. Insert
a short screw (D) into a hole and tighten with the
screwdriver. Repeat for all four legs. With a help of
the partner lift the storage o the ground, turn it
upright and place on a at surface
Step 2 Place the base on it’s legs. Using a screwdriver insert
cam screws (A) into the side holes.
D x 24
A x 6
D
A

Step 3 Place the top panel on it’s back. Using a screwdriver
insert cam screws (A) into the side holes.
A x 6
Step 4 Place the side wall on it’s back. Using a screwdriver
insert cam screws (A) into the smaller holes of the
shelf support. Repeat for the other side wall.
A x 4
A
A

Step 5 Align the side walls with the shelf so that the cam
screws t into side holes of the shelf. Insert cam locks
(B) into the top holes of the shelf and tighten using a
screwdriver.
B x 4
B
B
B
B

Step 6 Align the side walls with the base and top panel so
that the cam screws t into side holes. Insert cam
locks (B) into the side holes of the walls and tighten
using a screwdriver.
B x 12
BB
B

Step 7 Align the back side to the formed wardrobe body and
secure it with small screws (C) using a screwdriver.
C x 32
C

Step 8 Fit the hang rail inside of the wardrobe.
Align the hinges (D) to the side walls and secure
them with two long screws (E) using a screwdriver.
Align the doors to the hinges and connect them.
D x 6
E x 12
D
E

Step 9 Adjust the door hinges as shown, using a screwdriver.

Step 10 Fix a mounting plate (aa) to the back of the unit
using at head screws (cc).
By using appropriate fastener based upon wall com-
position, x another mounting plate (aa) to the wall.
Connect two plates with the nylon srap (bb).
Tighten the strap so that the unit is xed in the
place.
aa x 2
cc x 3
bb x 1
aa
WALL
cc
aa
cc