BROSA Mia Console Table With Drawers User manual

ASSEMBLY GUIDE
Mia Console Table With Drawers
v1.0

Components
Upon unpacking your console table from it’s delivery box, you should have
the pieces shown below. Follow the steps on the next pages to assemble
your new table.
30MIN
Hex head bolt
06 x 15mm
Flat head screw
04 x 17mm
Leg frame x 2
x 12
x 1
x 1
1Drawer box unit x 1
Allen key
Nylon strap
Mounting plate
x 2
x 2
3
A
aa
B
bb
cc
Item Qty.Description Item Qty.Description

Step 1 Remove the drawers from the unit and set aside.
Step 2
A x12
B x 1
2.1 Lay drawer box unit (2) on a surface.
2.2 Position both leg frames (1) onto the pre-drilled holes on
drawer box unit (2) as shown. Ensure the pre-drilled holes on
leg frames (1) are aligned correctly with the pre-drilled holes
on drawer box unit (2) before attaching.
2.3 Secure both parts (1) to part (2) using hex head bolts (A) as
shown. Use allen key (B) to turn ttings (A) clockwise to x.
Continue to re-tighten ttings (A) until they are securely
fastened.

Step 3 Stand the unit upright and reinsert the drawers.
Assembly is complete and enjoy your new table!

Tip Kit Instructions
Notice: To prevent injury and property damage from unexpected tipping of furniture,
we highly recommend installation of the anti-tip kit included with this project.
Attaching furniture to wall with anti-tip kits.
1.
2.
3.
4.
5.
Determine where the piece is to be placed and mark location on the wall for the
mounting bracket screw holes. ey should be place approximately 1” below the
bottom of the back of the piece of furniture.
Drill the hole and use the appropriate wall plug that is suitable for your walls
composition. Warning:before drilling check wall for hidden pipes and cables.
Attach the mounting bracket vertically to the wall using appropriate fastener,
through the holes in the bracket and 2 wall plugs that are suitable to your wall and
then tighten securely.
Next using the short screws attach the 2nd bracket to the back of the piece of
furniture’s top.
Lace the nylon strap through the brackets. Slide the thin end of the strap through
the receiving end of the nylon strap. Pull to tighten the piece of furniture snug
against wall.
Wood Brick or Masonry Cavity Wall
If fixing to
wood make
sure that is isn’t
chipboard as
screws can
easily pull
away from the
core structure.
Use an
appropriate
wall plug
provided when
you are sure
your wall is
sound.
Special toggle
wall plugs are
needed. Seek
expert advice.