BROSA Nancy Tall Boy User manual

ASSEMBLY GUIDE
Nancy Tall Boy
v1.0

Components
Upon unpacking your storage from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new storage.
Hardware
What you need
Legs x 2Body x 1
A x 10 (Bolt)
(Spec: M6xL32)
B x 10 (Washer)
(Spec: 14x8)
C x 1
(Mounting Plate)
D x 2
(Dowel)
E x 2 (Screw)
(Spec: 3.5xL35)
F x 2 (Washer)
(Spec: 10x4x1)
G x 10
(Plastic Cap)
H x 10
(Screw)

Step 1
A x 10
B x 10
Align a leg to the underside of the body so that the screw
holes are overlapping. Fit a washer (B) to a bolt (A) and screw
into a hole using a screwdriver. Repeat for the other holes
then for the second leg. Cover the bolt holes with the plastic
caps (G).
B
AG
G x 10

Step 2
D x 2
Find a nice spot for the night stand and make two holes in
the wall using a drill and 7mm drilling head. Distance of the
holes should be 37mm and height from the oor around
1177mm. Using a hammer instert two dowels (D) into the
holes.
7
37
D
WALL
≈117 7

Step 4 Attach the storage to the Mounting Plate.
C
F
E
WALL
WALL
Step 3
C x 1
E x 2
F x 2
Fit a washer (F) to a screw (E) and x the Mounting Plate (C)
to the wall using a screwdriver.

Step 5 Align the drawer slides to the corresponding holes
on the side walls. Secure into place using small
screws (H).
H x 6
Step 6 Continue using the screws to secure the slides.
H x 4
H
H
H

Step 7 Align the end hole on the drawer with the hook on the
slide and insert the drawer halfway into the cabinet.
Step 8 Pull the side lock out.

Step 10 Pull back the side lock to x the drawer on the slide
and close the drawer.
Step 9 Alight the vertical knob on the slide with the hole on
the drawer and lift the drawer down.

Step 11 Follow those steps to remove the drawer from the
storage. Open the drawer, open the lock (2) to the
side, pull the second lock (3) up and take out the
drawer (4). Repeat the steps in reverse order to put
the drawer back in it’s place.
1
4
2
3

Step 12
±2mm
Rotate the knob on the side of the drawer to adjust
the correct angle.

Step 12 Place the storage upright on a level surface. Enjoy
your new storage!