BROSA Haruki Lamp Table User manual

ASSEMBLY GUIDE
Haruki Lamp Table
v1.0

Components
Upon unpacking your table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new table.
Table top x 1
Leg x 2
Hardware
What you need
A x 8
Spec: Ø8 x 35mm
B x 1
Spec:

Step 1 1.1 Lay the table top (1) on a level surface with the
underside facing upward. Align one leg (2) to the
corresponding holes on the table top (1) and insert a
bolt (A) in each hole screwing it into place. Use the
allen key (B) to tighten. Repeat for the other leg.
1.2 Gently lift the table and place it upright on a level
surface. Enjoy your new lamp table!
Step 1.1
Step 1.2
A x 8
B x 1

Step 2 e following steps are to intruct how to remove and
insert the drawer.
2.1 To remove the drawer, pull it out and unlock by
lifting up both locking pads on either side of the
drawer and then remove it.
2.2 To insert the drawer, align it to the unit and push
back inside and once the drawer is in place the locking
pads on both sides will automatically lock.
Step 2.1
Step 2.2