BROSA Edward Bed End Ottoman User manual

ASSEMBLY GUIDE
Edward Bed End Ottoman
v1.0

Components
Upon unpacking your ottoman from it’s delivery box, you should have one
single component (the body of the ottoman). Additional components are
packed inside the body, you will learn how to access and utilise these
components in the next steps.
Ottoman body x 1
Unpacking
B x 2 (Leg)
C x 12 (Bolt)
D x 12 (Washer)
E x 1 (Allen Key)
A x 4 (Leg)
Turn the ottoman body so that the underside is facing you. Lift the fabric of
the base of the chair to reveal the hidden compartment where the
counterparts of the chair are hidden. Remove the parts and leave the hidden
compartment open as you need access for assembly.

Lift the ottoman o the ground and turn it right side
up while being careful not to put any pressure on the
legs while you turn the ottoman.
Step 1
Step 2
Align each leg (A) into the corner slots and each leg (B)
into the middle slots. Fit a washer (D) to a bolt (C) and
t it into one of the screw holes. Repeat for the second
screw. Turn the bolt with the allen key (E) until it is
secure, but do not tighten yet. Repeat for all six legs.
A x 4
B x 2
C x 12
D x 12
E x 1
AA
B
C
D
E
A
B
A

Place the ottoman on a at surface, then sit on the
ottoman and shift your weight around until the legs
are level and the ottoman does not rock. en use
the allen key (E) to tighten all the bolts and replace
the cover on the underside of the ottoman body to
concel the hidden compartment.
Enjoy your new ottoman!
Step 3
E x 1