BROSA Prato Bedside Table User manual

ASSEMBLY GUIDE
Prato Bedside Table
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
Body x 1 Leg x 4
Hardware
What you need
2
A x 12
(Spec: M6x15)
B x 12
(Spec: 8x14)
C x 4
(Spec: 15)
D x 30
1

Step 1
B
C
A
A x 12
B x 12
C x 4
Align a leg to the underside of the body so that the screw
holes are overlapping. Fit a washer (B) to a bolt (A) and screw
into a hole using a screwdriver. Repeat for the other legs. Peel
o the sticker paper and cover end of the legs with the trim
caps (C).

Step 2 Align the drawer slides to the corresponding holes
on the side walls. Secure into place using small
screws (H).
D x 6
Step 3 Continue using the screws to secure the slides.
D x 4
D
D
D

Step 4 Align the end hole on the drawer with the hook on the
slide and insert the drawer halfway into the cabinet.
Step 5 Pull the side lock out.

Step 7 Pull back the side lock to x the drawer on the slide
and close the drawer.
Step 6 Alight the vertical knob on the slide with the hole on
the drawer and lift the drawer down.

Step 8 Follow those steps to remove the drawer from the
storage. Open the drawer, open the lock (2) to the
side, pull the second lock (3) up and take out the
drawer (4). Repeat the steps in reverse order to put
the drawer back in it’s place.
1
4
2
3

Step 9
±2mm
Rotate the knob on the side of the drawer to adjust
the correct angle.

Step 10 With another person, lift the storage o the ground
and place it upright on a level surface.
Enjoy your new storage!