BROSA Parc Media Unit User manual

ASSEMBLY GUIDE
Parc Media Unit
v1.0

Components
Upon unpacking your media unit from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new media unit.
1
2
Media unit x 1
Leg x 4
A x 8
Spec: 5/16 x 60mm
B x 8
Spec: Ø8 x Ø14mm
D x 4
Spec: Ø3.5 x 11mm
E x 1
Spec: M5
C x 2
Spec:
Hardware What you need

Step 1
B x 8
E x 1
A x 8
Align a leg (2) to the underside of the media unit (1)
so that the screw holes are overlapping. Fit a washer
(B) to a bolt (A) and screw into a hole and repeat for
the other bolt to secure the leg in place. Repeat
process for the remaining legs (2) and use the allen
key (E) to tighten all of the bolts (A).
Step 2 Lift the media unit and turn it upright placing it rmly
down on a level surface. Align a handle (C) to its
corresponding place and secure it with two screws (D).
Repeat for the remaining handle (C).
D x 4
C x 2
1
2
A
E
B
D
C

Step 3 e media unit is 100cm wide by 52cm high and 43cm
deep and can take up to 60kg maximum weight on top
and 5kg inside each draw. Enjoy your new media unit!
52.0cm
100.0cm
43.0cm
60KG
MAX
5KG
MAX
5KG
MAX