BROSA Nara Dining Table User manual

ASSEMBLY GUIDE
Nara Dining Table
v1.0

Components
Upon unpacking your dining table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dining table.
What you need
Hardware
A x 8
Spec: Ø6 x 40mm
B x 10
Spec: Ø6 x 10 x 1.8mm
C x 10
Spec: Ø6 x 12 x 1.5mm
D x 1
Spec: M4
E x 2
Spec: Ø8 x 40mm
F x 4
Spec: Ø20 x 30mm
Table top x 1
Leg (1) x 2
Leg (2) x 2
1
1
2
2
3

Step 1
A x 2
B x 2
C x 2
D x 1
E x 2
1.1 Insert a dowel (E) in the middle hole of leg (1) and
join together with the other half of leg (1). Repeat for
the other leg (2).
1.2 Fit a spring washer (B) to a bolt (A) followed by a
at washer (C) and screw into the hole in leg (1) as
shown. Use the allen key (D) to tighten the bolt (A)
and repeat for the remaining leg (2).
AB
C
D
E
11
2
2
Step 1.1
Step 1.2

Step 2 2.1 Align leg structure (1) to the underside of the table
top (3) so that all of the holes overlap. Fit a spring
washer (B) to a bolt (A) followed by a at washer (C)
and screw it into a hole. Repeat for the remaining
bolts (A) and use the allen key (D) to tighten them in
place. Repeat process for leg structure (2).
2.2 Screw a rubber grip (F) into each hole on the
bottom of the leg structures (1 & 2).
1
2
3
D
F
A
B
C
A x 8
B x 8
C x 8
D x 1
F x 4
Step 2.2
Step 2.1

Step 3 Gently lift the table and place upright on a level surface.
Enjoy your new dining table!