BROSA Alicia Ottoman User manual

ASSEMBLY GUIDE
Alicia Ottoman
v1.0

Components
Upon unpacking your ottoman from it’s delivery box, you should have one
single component (the seat of the ottoman). Additional components are
packed inside the seat, you will learn how to access and utilise these
components in the next steps.
Ottoman seat x 1
Turn the ottoman seat so that the underside is facing you. Remove the cover
from the base of the ottoman to reveal a hidden compartment where you’ll
nd the rest of the parts of the ottoman. Take these out and leave the cover
o as you need access to the underside of the ottoman to t the legs.
Unpacking
A x 4 (Leg)
B x 8 (Bolt)
C x 8 (Spring Washer)
D x 8 (Flat Washer)
E x 1 (Allen Key)

Step 1 Align a leg (A) to the seat of the ottoman. Fit a spring
washer (C) to a bolt (B) followed by a at washer (D)
and screw into a hole. Repeat for the second screw to
t the leg into the frame of the ottoman. Turn the
bolt with the allen key (E) until it is secure but do not
tighten yet. Repeat for all of the remaining legs.
D EBC
A
A A
A
Step 2 Lift the ottoman o the ground and turn it right side
up while being careful not to put any pressure on the
legs while you turn the ottoman.
A x 4
B x 8
D x 8
C x 8
E x 1

Step 3 Place the ottoman on a at surface, then sit on the
ottoman and shift your weight around until the legs
are level and the ottoman does not rock. en use
the allen key (E) to tighten all the bolts and replace
the cover on the underside of the ottoman seat to
conceal the hidden compartment.
Enjoy your new ottoman!
E x 1