BROSA Elizabeth Nesting Tables User manual

ASSEMBLY GUIDE
Elizabeth Nesting Tables
v1.0

Components
Upon unpacking your nesting tables from its delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new nesting tables.
Table top x 1
Table top x 1
Leg x 2
Leg x 2 Leg x 2
Leg x 2
Hardware
What you need
D x 8
Spec: Ø8.4 x 2mm
E x 8
Spec: M8 x 13mm
F x 1
Spec:
A x 8
Spec: M8 x 12 x 30mm
B x 8
Spec: M8 x 60mm
C x 8
Spec: Ø8.4 x 17 x 1.6mm

Step 1 1.1 Insert a cross dowel (A) into the hole at the top of
each leg (3, 4, 5 & 6) making sure it sits facing the
correct direction as shown.
1.2 Insert a threaded bolt (B) into the hole on the side
of each leg (3, 4, 5 & 6) screwing it tightly in place.
A x 8
B x 8
Step 1.2
Step 1.1

Step 2 Starting with the larger table, align a leg (3 or 4) to the
underside of the table top (1) making sure the threaded
bold (B) protruding from the leg ts into the hole in
the frame. Also make sure that the legs are facing the
correct direction as shown in the diagram. Fit a at
washer (C) to the bolt (B) followed by a lock washer
(D) and a nut (E) using the spanner (F) to tighten the
nut in place. Repeat for the remaining legs (3 & 4).
Repeat the whole process for the smaller table using
table top (2) and legs (5 & 6).
E x 8
C x 8
D x 8
F x 1

Step 3 Gently lift each table upright and place on a level
surface, nesting the smaller table underneath the larger.
Enjoy your new nesting tables!

Step 5 e following steps are to instruct how to apply the anti
tip kit (which is optional, but recommended).
5.1 Align the mounting bracket (aa) to the back of the
dressing table and secure in place with the screws (cc).
5.2 At the location the dressing table will be placed,
mark out two holes on the wall for the other bracket
(aa) and using a drill form the holes. Warning: check
the wall for hidden pipes and cables before drilling
holes. Attach the mounting bracket (aa) to the wall with
suitable plugs for your wall type. read the nylon strap
(bb) through both of the backets and secure rmly.
aa x 2
bb x 1
cc x 2
Step 5.2
Step 5.1