BROSA Beaudan 2-Seater Sofa User manual

ASSEMBLY GUIDE
Beaudan 2-Seater Sofa
v1.0

Components
Upon unpacking your sofa from it’s delivery box, you should have one single
component (the body of the sofa). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Sofa body x 1
Turn the sofa body so that the underside is facing you. Remove the cover
from the base of the sofa to reveal a hidden compartment where you’ll nd
the rest of the parts of the sofa. Take these out and leave the cover o as you
need access to the underside of the sofa to t the legs.
Unpacking
A x 2 (Front Leg)
B x 2 (Back Leg)
C x 8 (Bolt)
D x 8 (Spring Washer)
E x 8 (Flat Washer)
F x 1 (Allen Key)

Step 1 Starting with the front legs, insert a leg (A) into the
corresponding slot. Fit a spring washer (D) to a bolt
(C) followed by a at washer (E) and t it into one of
the screw holes. Repeat for the second screw to t
the leg into the frame of the sofa. Turn the bolt (C)
with the allen key (F) until it is secure but do not
tighten yet. Repeat for all remaining legs. Please note
that the back legs (B) are both the same and are to
only go at the back of the sofa.
Step 2 Lift the sofa o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the sofa.
B x 2
A x 2
C x 8
E x 8
D x 8
F x 1
A A
B B
E C FD

Step 3 Place the sofa on a at surface, then sit on the sofa
and shift your weight around until the legs are level
and the sofa does not rock. en use the allen key (F)
to tighten all the bolts and replace the cover on the
underside of the sofa body to conceal the hidden
compartment. Enjoy your new sofa!
F x 1