BROSA Windsor Wingback Armchair User manual

ASSEMBLY GUIDE
Windsor Wing Back Armchair
v1.0

Turn the chair body so that the underside is facing you. Remove the cover
from the base of the chair to reveal a hidden compartment where you’ll nd
the rest of the parts of the chair. Take these out and leave the cover o as you
need access to the underside of the chair to t the legs.
Components
Upon unpacking your chair from it’s delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Chair body x 1
Unpacking
B x 2 (Back Leg)
C x 8 (Bolt)
D x 8 (Washer)
E x 8 (Spring Washer)
F x 1 (Allen Key)
A x 2 (Front Leg)

Starting with the front legs, insert a leg (A) into the
corresponding slot. Fit a spring washer (E) to a bolt
(C) followed by a washer (D) and t it into one of the
screw holes. Repeat for the second screw to t the leg
into the frame of the chair. Turn the bolt with the
allen key (F) until it is secure but do not tighten yet.
Repeat for all four legs. Please note that the back legs
(B) are both the same and are to only go at the back
of the chair.
Step 1
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
F x 1
E x 8
D x 8
C x 8
B x 2
A x 2
AA
B
B
C
E
D

F x 1
Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(F) to tighten all the bolts and replace the cover on
the underside of the chair body to conceal the hidden
compartment. Enjoy your new armchair!