BROSA Warner Trestle Dining Table User manual

ASSEMBLY GUIDE
Warner Trestle Dining Table
v1.0

Components
Upon unpacking your dining table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dining table.
Hardware
A x 1
Spec: M5
B x 14
Spec: Ø8 x 19 x 1.2mm
C x 8
Spec: Ø8 x 63mm
D x 2
Spec: Ø8 x 45mm
E x 2
Spec: Ø8 x 57mm
F x 2
Spec: Ø8 x 38mm
What you need
Table top x 1
Cross brace x 1
Support
beam x 2
Support
beam x 1
Leg x 2
1
3
3
5
4
2
2

Step 1
Step 2
Align the cross brace (5) to a leg (2) tting them together
and repeat for the other leg (2). Fit a washer (B) to a bolt
(F) and screw into the hole on the leg (2) using the allen
key (A) to tighten. Repeat for the other bolt to secure the
cross brace (5) in place.
On the underside of the table top (1), align and t the
support beam (4) in place as shown. Align the
structure formed in Step 1 to the underside of the table
top (1). Fit a washer (B) to a bolt (C) and screw into a
hole using the allen key (A) to tighten. Repeat for all
of the remaining bolts.
B x 2
F x 2
A x 1
B x 8
C x 8
A x 1
B
F
A
5
2
2
1
4
B
C
A

Step 3
Step 4
Align a support beam (3) to its corresponding place. Fit a
washer (B) to a bolt (E) and screw it into the hole on the
cross brace, repeating for the second bolt (D) for the
hole closer to the table top. Use the allen key (A) to
tighten the bolts before repeating the same process to
secure the other support beam (3).
Gently lift the table and place upright on a level surface.
Enjoy your new dining table!
A
B
E
A
B
D
3
3
B x 4
D x 2
E x 2
A x 1