Burg KeyPad Outdoor IP54 User manual

KeyPad Outdoor IP54
Operating Manual
www.burg.de

KeyPad Outdoor IP54 | 11-2019 Rev. 03 | English | 2
Introduction 2
General 2
Default Settings 2
Technical Data 3
Scope of Delivery 3
Features 3
Dimensions 3
Functional Description 4
Configuration 4-5
Operation 5
Battery Replacement 5
Disposal 5
Content
Dear Customer,
Thank you for choosing the KeyPad Outdoor IP54 - the com-
pact electronic code lock with vandal-proof silicone keypad.
Due to its innovative housing, the KeyPad is well protected
against weather and environmental influences. Regardless of
whether rain or jet water - the housing effectively protects
against moisture and the innovative seals prevent the entry of
dust or sand.
Important: Please note all warnings and read through the
entire operating manual before you begin configuration.
We hope you enjoy using your new locking system.
Sincerely, BURG F.W. Lüling KG
Introduction
The latest version of this guide is always available on our web-
site: www.burg.de
General
KeyPad Outdoor IP54
ATouchpad buttons BStatus LED
CLatchbolt DSilicone pad
B
D
A
C
Mode Multi User Mode
Master Code 934 716
PIN length 4 digits
LED locking indication On
Code confirmation Off
Locking direction left1
Default Settings
1 Locking direction left for right-hinged doors.

KeyPad Outdoor IP54 | 11-2019 Rev. 03 | English | 3
KeyPad
Touchpad
68,9 mm
68,9 mm
11,3 mm
2,7 mm
19,8 mm 30 mm
Silicone keypad
Back unit with battery compartment
Battery
Fixing screw
Scope of Delivery
Intuitive operation
IP54 protection (even with salt water)
UV and corrosion protection
Compact dimensions
Simple installation with only one screw
Private and Multi User Mode
Emergency opening function with Master Code
Features
Dimensions in mm Keypad: 68,9 x 68,9 x 11,3
Back unit: 70,4 x 70,4 x 24
Battery 1 x Lithium battery 3V, CR123A
Locking cycles Approx. 45.000
Working temperature 0°C to +60°C
(no formation of condensation)
Protection class IP54
No. of code combinations 999.999
Code length 4 or 6 digits
Programming Multi User Mode
Private Mode
Material Keypad: Silicone
Keypad core: Zamac
Back unit: Plastic
Locking bolt Plastic
Locking direction L, R
Lock attachment Raised countersunk screw
5x16, Torx 20
Max. door thickness 2 mm
Factsheet
Keypad
Back unit
Technical Parameters
Dimensions
Keypad
Back unit
KeyPad
Back unit
70,4 mm
70,4 mm
29,9 mm
24 mm
KeyPad
Back unit
70,4 mm
70,4 mm
29,9 mm
24 mm

KeyPad Outdoor IP54 | 11-2019 Rev. 03 | English | 4
Mode: Fixed Assigned Authorization (Private Mode)
In this mode, a code is pre-set with which the lock can be ope-
rated. This mode is suitable for user groups where user rights
do not have to change permanently e.g. in an office cabinet. To
close, the user holds down the hook key. The lock is opened by
entering a stored code. Up to 50 codes can be stored. A code
that has not been stored is rejected by the lock.
Mode: Multi User Authorization (Multi User Mode)
This mode is suitable for constantly changing users who only use
the compartment temporarily or once, e.g. in a sports facility.
Codes are valid for a single locking process and are deleted by
the lock when the compartment is reopened so that a new code
can be used. The locking bolt remains open until a new code
locks the lock again. Before locking, the door must be closed
(slightly pressed). The user enters a code of choice (4 to 6 digits)
to close and confirms the entry by pressing the hook key twice.
The green LED starts flashing. The lock is opened by entering
the same code.
LED Locking Indication
When the locking indicator is activated, the red LED flashes eve-
ry second when the lock is locked. When the lock is open, the
LED does not flash. This function can be switched on or off.
Code Confirmation
To close the lock, a double code entry is required, with the
second entry confirming the first entry. The lock does not lock
until the entry has been repeated. The second entry is made af-
ter the green LED flashes briefly. A simple code entry is sufficient
to open the lock. This function can be switched on or off.
Battery Warning
If the battery capacity falls below a certain limit, the red LED
lights up for three seconds after the code has been entered. If
the critical range is reached, the lock can no longer be locked or
can only be opened with Master Code.
Note: We recommend to change the battery after the first
warning.
Master Code
The master code authorizes the programming of the lock. The
lock can also be opened via the Master Code if the code is lost.
In Multi User Mode, the code used for locking is deleted after
entering the Master Code.
Note: Please program for your own safety your own Master
Code prior to use.
Block Mode
After 4 failed opening attempts, the lock blocks for 45 seconds
so that no code can be entered in the meantime. The locking
time is indicated by the red LED flashing every second. The block
mode can be cancelled by entering the Master Code.
Functional Description Configuration
Each step of a configuration is completed with the green LED
flashing twice. It is absolutely necessary to start the next
configuration step only after the green LED has flashed
twice. If the configuration step is not carried out correctly, the
lock signals this by flashing the red LED 8 times in quick succes-
sion.
1Select Mode
a) Private Mode
Enter Master Code  1 Master Code
Set mode  5 0 
Note: To set the private codes, please go to point 3a „Set the
code“.
b) Multi User Mode
Enter Master Code  1 Master Code
Set mode  5 1 
Note: After changing the mode, all functions are reset to the de-
fault settings. This does not apply to the master code.
2Set the Code Length
Enter Master Code  1 Master Code
Select number of digits  0 x 
4 digits: x = 4
6 digits: x = 6
Note: After changing the number of digits, all codes stored in
Private Mode are deleted.
3Set Functions
Depending on the mode, certain functions are available for
configuration. Set the functions assigned to the mode according
to your requirements.
a) Configuration in Private Mode
Set the code
Enter Master Code  1 Master Code
Set code  3 xxxx (xx)
Up to 50 private codes can be stored. Depending on the set
code length, these must have 4 or 6 digits
Delete the code
Enter Master Code  1 Master Code
Delete code  9 xxxx (xx)
Enter the code you want to delete.

KeyPad Outdoor IP54 | 11-2019 Rev. 03 | English | 5
b) Configuration in Multi User Mode
Activate/ deactivate code confirmation
Enter Master Code  1 Master Code
Activate  2 1
Deactivate  2 0
c) Set General Functions
The following functions can be configured regardless of the
mode set.
Set own Master Code
Enter current Master Code  1 Master Code
Enter new Master Code  7 xxx xxx
The Master Code must be 6 digits long.
Activate/ deactivate LED locking indication
Enter Master Code  1 Master Code
Activate  8 1
Deactivate  8 0
Set right/ left usage
Enter Master Code  1 Master Code
Set locking direction x
left: x = 4
right: x = 6
1Operation in Private Mode
Lock „“(hold down)
Unlock Enter code
2Operation in Multi User Mode
Lock Enter code + 
Unlock Enter code
3Enter the Master Code
The Master Code must always be entered as follows:
Enter Master Code  1 Master Code
Note: When unlocking in Multi User Mode by the Master Code,
the code used for locking is deleted after entering the Master
Code.
Operation
Battery Replacement
1Loosen the battery cover screws on the back.
2Remove the battery cover.
3Remove the battery.
4Insert new battery according to +/- icons.
5Close the battery cover with the screws on the back.
Electrical and electronic equipment („old devices“) as well as bat-
teries and accumulators may not be disposed of with household
waste. For proper disposal, these devices must be brought to a
designated collection point.
Every consumer is legally obliged to dispose of batteries or
rechargeable batteries or devices, which are operated with
batteries or rechargeable batteries separately from the house-
hold waste, as they contain pollutants and valuable resources.
Disposal may take place at an approved collection point. This can
be, for example, a local recycling center. Old electrical appliances,
batteries or rechargeable batteries are accepted there free of
charge and used for environmentally beep and resource-efficient
recycling.
You can also return your old electrical appliances or used batteries
to us. The return must be done in each case sufficiently franked:
BURG F.W. Lüling KG
Volmarsteiner Straße 52
58089 Hagen
On batteries containing harmful substances you will find infor-
mation in the form of abbreviations on the ingredients cadmium
(Cd), mercury (Hg) and lead (Pb). Batteries are marked with the
following symbol, which means that they must not be disposed
of with household waste:
BURG F.W. Lüling KG
Hegestraße 6
58300 Wetter (Germany)
Fon +49 (0)23 35/ 6308-0
Fax [phone]
[e-mail]
www.burg.de
Entsorgung
Image rights: cover image, metal structure, Zerbor / 123rf