Cleveland KGL-100 User manual

Cleveland
™
Project ________________________________
Item __________________________________
Quantity _______________________________
FCSI Section ____________________________
Approval _______________________________
Date __________________________________
1333 East 179 St.,
Cleveland, Ohio, U.S.A. 44110
Tel: [phone]
Fax: [phone]
Web Site: www.ClevelandRange.com
Email: [e-mail]
GAS KETTLES
MODELS:cKGL-40 cKGL-80
cKGL-60 cKGL-100
Cleveland Standard Features
nHigh efficiency Power Burner Heating System
(62% to 65% efficiency)
nFast Heat-up and Recovery Time, 140M BTU’s on 40 gallon
models, 190M BTU’s on 60 gallon and larger
nInsulated Heat Exchanger
nAutomatic Ignition System
nSteam jacket permanently filled with treated, distilled water.
Venting and/or refilling not required
nSolid State Controls, for Temperature and Low Water Safety,
in a plug-in Control Module
nControl Panel includes:
nPrecise, consistent temperature control: less than
n± 1°C variance (ideal for simmering).
nL.E.D. Indicators for Heat Cycle and Low Water
nWarning.
nPower
“on/off” Switch
nFront mounted combination Pressure/Vacuum Gauge
nType 304 Stainless Steel with #4 finish on kettle and
supports
n2˝ diameter Tangent Draw-Off Valve with Drain Strainer
nSupport Legs with level adjustable feet, flanged for floor
bolting
nSpring-assisted, hinged, rotatable, domed Stainless
Steel Cover
n50 PSI Steam Jacket Rating and Safety valve
nStandard voltage is 115 volts, 60 Hz, single-phase, supplied
with cord and plug
nStandard for natural gas operation
nFaucet Mounting Bracket (FBK)
nTypical approvals include AGA, CSA, CE, NSF and ASME
Options & Accessories
pType 316 Stainless Steel Kettle Liner for high acid food
products (316)
pHot and Cold Water Faucet with Swing Spout (DPK)
pCooking Baskets and Tri-Basket Supports (BS and TBS)
pDrain Strainers (DS-)
p3" diameter Tangent Draw-off Valve with Drain Strainer (TD3)
Shall be CLEVELAND, Gas-fired Stationary Kettle, Model
KGL-_____ ; _____ gallons. 2⁄3 Steam Jacketed, Power Burner Heating
System, Insulated Heat Exchanger, 50 psi Steam Jacket Rating.
Infinite Variable Temperature Control, L.E.D. indicators for Heat Cycle
and Low Water Warning, spring-assisted Cover, 2˝ Tangent Draw-off
Valve with Drain Strainer, Automatic Ignition System.
pKettle Accessory Kit (KAK) includes:
pClean-up Brush(CB) p36”Kettle Paddle (KP)
p36”Kettle Whip(KW) p36”Kettle Brush (KB)
pDraw-off Brush (DB) p24 oz. Ladle (KL)
pAutomatic Water Meter (GMF or LMF)
pMeasuring Strip (MS)
pOption for Propane Gas operation
pCorrectional Package
pHeat Deflector Shield (HS001)
ShortFormSpecifications
LEG TYPE, GAS-FIRED KETTLES
STATIONARY, 2⁄3 STEAM JACKETED
“SPLASH PROOF SERIES”
40, 60, 80 or 100 GALLONS (150, 225, 300 or 337 LITERS)
SECT. IX PAGE 9
0707

NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Installation of backflow preventers, vacuum breakers and other specific coder requirements is the responsibility of the owner and installer.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L., A.G.A., NSF, ASME/N.Bd., CSA, CGA, ETL and others.
1⁄2˝dia. Soft
Copper
Tubing (each)
When
ordered with
optional
faucet.
WATER
ELECTRIC
120V-1 Phase, 60 Hz, 10
amps
GAS CLEARANCE
H
RIGHT =3˝
LEFT = 3˝
REAR = 3˝
Allow 6˝ space minimum
from rear and sides when
located near combustible
walls. 12" recommended on
right side for service
NATURAL PROPANE
Piping: 3⁄4˝N.P.T. Piping: 3⁄4˝N.P.T.
Supply pressure: Supply pressure:
4.00˝ W.C. minimum 4.00˝ W.C. minimum
14.00˝ W.C. maximum 14.00˝ W.C. maximum
Manufacturer must be notified if unit will be operated above 2,000 ft. altitude.
C
H
C
B.T.U. RATING
40 gal. 140,000
60 gal.
80 gal. 190,000
100 gal.
SECT.IX PAGE 10
0707
Litho in U.S.A.
G
(COVER
OPEN)
3" (77 mm) 
MINIMUM 
CLEARANCE
F
3(77 mm)
L
M
N
O
P
H
J
K
FLOOR DRAIN 
12" (305
mm) WIDE x 
12" (305
mm) LONG
UNIT SHOWN WITH OPTIONAL 2" TANGENT DRAW-OFF VALVE,
SPRING ASSIST COVER AND HOT & COLD WATER FAUCET.
75º
HC
E
D
A
S
C
4" (102 mm)
B
T
(I.D.)
RECOMMENDED
FLOOR SLOPE
1" (26 mm) per 4' (1220 mm)
PIPE DRAIN RECOMMENDED
min. valve size plus 1" (26 mm)
4" (102 mm)
RECOMMENDED
9/16"
14 mm
120º
TYP
1" (25
mm)
MAX. ADJUSTMENT
15/8" (42 mm) Ø
FLANGED FOOT DETAIL
7/16" (11 mm) Ø
3 HOLES ON
31/8" (80
mm) Ø
B.C.D.
4 7/8"
124
Ø mm
VALVE
OPENING
DIMENSIONS
GALS./
LITERS A B C D E F G H J K L M N O P S T I.D.
40 IN 35 1/8 37 32 1/4 40 1/2 9 1/4 16 71 1/2 9 9/16 17 3/4 25 15/16 10 3/8 18 5/8 26 7/8 28 1/2 4 5/8 24 1/2 26
150 mm 893 940 820 1029 235 407 1817 243 451 659 264 474 683 724 118 648 661
60 IN 38 1/4 39 34 1/4 43 1/2 8 3/4 14 1/4 75 8 15/16 19 1/8 29 5/16 10 3/8 18 5/8 27 7/8 30 1/4 5 1/4 27 29 1/2
225 mm 972 991 870 1105 223 362 1905 228 486 745 264 474 709 769 134 686 750
80 IN 41 5/8 42 3/8 35 1/2 45 1/2 8 3/4 15 1/2 79 9 1/4 20 3/4 32 1/4 10 3/8 18 5/8 29 5/8 31 1/2 6 5/8 29 33
300 mm 1058 1077 902 1156 223 394 2007 235 528 820 264 474 753 801 169 737 839
100 IN 44 43 1/2 36 1/2 47 1/2 8 3/4 15 1/2 83 1/2 9 1/8 21 7/8 34 5/8 10 3/8 18 5/8 31 1/4 32 1/2 7 1/2 30 1/2 35 1/2
375 mm 1118 1105 928 1207 22.3 394 2121 232 556 880 264 474 794 826 191 775 902
CAPACITIES: (in 8 oz. servings,
other sizes may be calculated)
40 Gallon / 150 liters . . . 640 servings
60 Gallon / 225 liters . . . 960 servings
80 Gallon / 300 liters . . . 1280 servings
100 Gallon / 375 liters . . . 1600 servings