Denali MA11729 User manual

866.527.7637 1 [e-mail]
23001 Industrial Blvd, Rogers, MN 55374 / 1-866-527-7637
www.motoalliance.com
DENALI Plow Mount
MA11729
Yamaha Wolverine
Thank you for purchasing a DENALI plow mount. You now own a premium, custom
plow mount to allow you to use your plow with your UTV/SxS. Please note the following
instructions and heed all warnings.
Your UTV/SxS and plow system can cause death or injury. Please use caution
and common sense when operating your unit.
Read your Plow Operator Manual, your Winch Operator Manual, and all warning
labels before operating your UTV/SxS.
Operate your UTV/SxS at a walking speed with the blade installed. Do not
exceed 5 mph (8 km/h) even with the blade up.
Do not operate the UTV/SxS on slopes greater than 10 degrees with the plow
installed.
Always lower the plow to the down position before leaving your UTV/SxS
unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

MotoAlliance
MA11729 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Contents:
Figure 1
Part #
Qty
Description
1
1
MA11729 Plow Mount
2
1
Front Support Bracket
3
6
3/8’’-16 x 1.00’’ Serrated Flange Bolt

MotoAlliance
MA11729 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
Yamaha Wolverine Plow Mount Installation
1. Remove the front plastic brush guard shown in Figure 2 and Figure 3. The MA11729
Plow Mount will replace the brush guard while in use.
Figure 2
Figure 3

MotoAlliance
MA11729 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
2. Position the Plow Mount (part 1) over the front of the Wolverine’s frame. Insert two of
the 3/8’’-16 x 1.00’’ Serrated Flange Bolts (part 3) into the rear supports as shown in
Figure 4 and tighten.
Please Note: weld nuts are engineered on the Plow Mount
Figure 4
3. Insert the Front Support Bracket (part 2) behind the front face of the Plow Mount
(part 1) such that the four holes in the Front Support Bracket (part 2) are visible
through the four holes in the front of the Plow Mount (part 1). Insert the remaining
3/8’’ x 1.00’’ Serrated Flange Bolts (part 3) as shown in Figure 5 and Figure 6.
Tighten the bolts.

MotoAlliance
MA11729 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 5 [e-mail]
Figure 5
Figure 6
4. Ensure that all hardware is tightened and attach the plow using the quick release
pins included with DENALI Plow Kits.