Elo TouchSystems 15A2 for wireless card User manual

Revision B
P/N E065273
821107901102
Installing additional RAM for the 17A2/15A2
2008 Tyco Electronics.
North America
Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com
Europe
Tel [phone]
Fax [phone]
[email protected]
Asia-Pacific
Tel [phone]
Fax [phone]
www.tps.co.jp
Latin America
Tel [phone]
Fax [phone]
www.elotouch.com.ar
Elo Technical Support
:
www.elotouch.com/go/websupport
www.elotouch.com/go/contactsupport
Online self-help
Technical Support contacts in your region:
For current Elo news, product updates and announcements, register to receive our TouchMonitor newsletter
at www.elotouch.com/go/news

4
To remove an existing memory module,
pull the two metal latches away from the
modules until the module is released.
The module should tilt up and then can
be safely removed.
Reconnect the power adapter and
power on the touchcomputer.
You may use the operating system
to verify that the additional memory
was installed properly.
Note on adding/removing memory modules:
Be careful, as improper installation or removal of a memory module can
cause harmful damage to your touchcomputer. Only install memory modules
that are compatible with your touchcomputer. The module packaged with this
accessory kit meets the requirements for this touchcomputer.
Be careful when handling a memory module, as ESD can damage the module.
Remove the four screws connecting the
stand to the chassis. Once these screws
are removed, the stand will come off.
Then remove the four screws on the
chassis.
Align the pins of the memory module
with the connector at an angle and
push it in until the pins are in place.
Then push the memory module down
until it clicks. If it clicks, then it means
the module was installed successfully.
1
Turn touchcomputer upside down and
take off the back cover insert
2
5
8
7
Replace the back cover insert.
6
3
Reinstall the four screws to close
the chassis and then reinstall the
stand using the screws removed
in Step 3.
Turn off power to the touchcomputer
and unplug the power adapter from
the unit.
●
Note: Always handle the component by its edges.
●
Installer must be electrically grounded while performing installation steps.