Elo TouchSystems Z10 User manual

Revision B
P/N E185186
www.elotouch.com
Quick Installation Guide
Z10 POS Stand
© 2021 Elo Touch Solutions, Inc. All rights reserved.
The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no
representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a
particular purpose. Elo reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation
of Elo to notify any person of such revisions or changes.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise without prior
written permission of Elo Touch Solutions, Inc.
Elo and the Elo logo are either trademarks or registered trademarks of Elo Touch Solutions, Inc..
America
800-ELO-TOUCH
Tel [phone]
[email protected]
Europe (EMEA)
Tel [phone]
[email protected]
Asia Pacific
Tel [phone]
[email protected]
Elo Technical Support
Online self-help: www.elotouch.com/support
Kit Contents
Stand
M4x6 mounting screws (4)
75mm VESA mount adapter for customer facing display

1
2
Button
Rotate the display mounting plate back as far as it will go. Remove the lower plastic cover to expose
the VESA mounting holes by pressing the button and sliding the cover down. Then slide the upper
cover o󰀨 the mounting plate.
Secure the I-Series 4 Slate Display to the stand by installing the M4x6 at-head screws (4 included
with stand kit) through the mounting plate and into the back of the display. Do not use longer or
shorter screws. Slide the plastic top cover over the mounting plate making sure the cover sits against
the rear of the display. Then slide the lower cover up until the button snaps in place.
3
4
Remove the cable cover door and route the USB-C cable from the I-Series 4 Slate Display under the
stand opening and connect to the USB-C port on the rear of the display. Replace the cable cover door.
Secure the USB-C cable on the back of the I-Series 4 Slate Display with the cable security bracket.
12
Cable Security Bracket Cable Security Bracket screw
See detailed user guide at www.elotouch.com for additional infomation on mounting
Elo ET0702L as a customer facing display.