It’s time to drum and sing along with Drummin' Billy! Billy plays
the drums and sings "Ants Go Marching One by One" and "Five
Little Bears Jumping on the Bed." Press his foot or your external
capability switch and he sings and drums for 30 seconds or until
you press his switch again. Each activation changes the tune he
sings. His mouth moves as he sings and his arms go up and
down in time to the music. Billy’s great for the budding drummer
or music lover in your life. Size: 9"L x 8½"W x "H. Requires 3
AA Batteries. Weight: ¼ lb.
Operation:
. Drummin’ Billy requires 3 AA batteries (Not included) to
operate. Use alkaline batteries only (e.g. Duracell or
Energizer brand). Do not use rechargeable batteries or any
other type of batteries because they supply lower voltage
and the unit will not perform properly. Never mix old and new
batteries together or different brands or types together.
2. The battery compartment is located on the bottom of
Drummin’ Billy. Open the Velcro flap, then using a Phillips
head screwdriver open and remove the batter cover. Next
install 3 AA batteries paying close attention to proper battery
polarity.
3. Set the On/Off switch to On. Replace the battery
compartment cover and secure it with the screw.
4. Connect Drummin’ Billy to any external capability switch (not
included) via the jack located at the end of his cord.
Drummin’ Billy is equipped with a /8" jack for use with
external capability switches with a /8" plug. Make sure you
have pushed the switch plug all the way in. There should be
no gaps.
5. Actuate your external capability switch or squeeze Drummin’
Billy’s foot with the musical note symbol. Billy plays the
drums and sings "Ants Go Marching One by One" and "Five
Little Bears Jumping on the Bed." Press his foot or your
external capability switch and he sings and drums for 30
seconds or until you press his switch again.
6. Each activation changes the tune he sings. His mouth
moves as he sings and his arms go up and down in time to
the music.
Troubleshooting:
Problem: Drummin’ Billy does not function correctly.
Action #1: Replace the batteries paying close attention to
proper battery polarity.
Action #2: Make sure that the connection between the external
capability switch is pushed in all the way. There should be NO
gaps.
Action #3: Try your switch with another switch operated
toy/device in an effort to rule out your switch as the source of
the problems.
Care of Unit:
If you will not be using Drummin’ Billy for an extended amount of
time, we recommend removing the batteries.
Do not submerge the unit in water, as it will damage the
electrical components. Drummin’ Billy is surface washable only.
Rev 6/28/2022
