A great sensory experience!
A great sensory experience!A great sensory experience!
A great sensory experience!
Our Gel Board provides both visual and tactile experiences. Four
colorful soft and squishy pads light up when you touch them. Each
pad contains multicolored stars that move when you press the pad.
Pads light up with the slightest touch. A bead chain and mirror invite
additional exploration. Use on a desktop or wall mounted. Wall
mounting hardware included. Size: 16½"L x 13½"W x 2"H. Requires 2
AA Batteries. Weight: 3½ lbs.
1. Illuminated Gel Board requires 2 AA batteries (not included . Use
Alkaline batteries only (e.g. Duracell or Energizer brand . Do not
use rechargeable batteries or any other type of batteries because
they supply lower voltage and the unit will not perform properly.
The battery compartment is located under the mirror. To access
the compartment lift off the Velcro attached mirror and then
remove the Phillips Head screw from the battery compartment
cover. Install the AA batteries into the holder. When installing new
batteries, always be careful to observe battery polarity. Replace
battery cover and screw. Never mix old and new batteries together
or different brands or types together.
2. Turn the ON/OFF toggle switch to ON. Our Gel Board provides both
visual and tactile experiences. Four colorful soft and squishy pads
light up when you touch them. Each pad contains multicolored
stars that move when you press the pad. Pads light up with the
slightest touch. Once you release pressure on the gel pad the light
will go out. A bead chain and mirror invite additional exploration.
Use on a desktop or wall mounted. Wall mounting hardware
included.
Troubleshooting:
Troubleshooting:Troubleshooting:
Troubleshooting:
Problem:
Problem:Problem:
Problem: UV Light Panel’s lights do not work.
Action #1:
Action #1: Action #1:
Action #1: Make sure the ON/OFF toggle switch is turned ON.
Action #2
Action #2Action #2
Action #2:
::
: Check the Batteries for strength and for proper battery
polarity. Replace if weak or dead.
Care of the Unit:
Care of the Unit:Care of the Unit:
Care of the Unit:
The Illuminated Gel Board can be wiped clean with any household
multi-purpose, non-abrasive cleaner and disinfectant. We recommend
Simple Green, which is a non toxic biodegradable all-purpose cleaner.
Do not use
Do not useDo not use
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit, as it will damage the electrical
components.
Rev
Rev Rev
Rev 5
55
5/3
/3/3
/3/17
/17/17
/17
