It’s your friendly neighborhood Spider-man and he’s ready for bubble
action! Activate him with a touch or with a capability switch (not
included) and he shoots bubbles instead of a web from his hand!
Spidey comes with 4 o . of non-toxic, dye-free bubble juice for instant
action. Si e: 4"L x 6"W x 9"H. Requires 3 AAA batteries. Weight: ½ lb.
Operation:
. Spider-Man Bubble Blower requires 3 AAA batteries (Not
included) to operate. Use alkaline batteries only (e.g. Duracell
or Energizer brand). Do not use rechargeable batteries or any
other type of batteries because they supply lower voltage and
the unit will not perform properly. Never mix old and new
batteries together or different brands or types together.
2. The battery compartment is located in the back of Spider-
Man’s head. Carefully turn Spider-Man over to reveal the
battery compartment cover. Using a Phillips head screwdriver
unscrew the cover screws and install 3 AAA batteries, paying
close attention to proper (+) and (-) battery polarity.
3. Replace the battery compartment cover and secure with the
screws. Connect to any external capability switch (not
included) via the jack located on the side of Spider-Man.
Spider-Man Bubble Blower is equipped with a /8″ jack for
use with external capability switches with a /8″ plug. Make
sure you have your switch plugged in all the way. There
should be no gaps.
4. The Bubble solution container is the bottom part of Spider-
Man. Just unscrew the bottom of Spider-Man Bubble Blower
and fill with bubble solution. Follow the original manufactures
instructions for installing.
5. Spider-Man Bubble Blower can be used with or without an
external switch. The ON/OFF switch is Spider-Man’s spider
symbol on his back. When using an external capability switch,
the ON/OFF switch needs to be set in the OFF position.
Actuate your external capability switch and the bubbles will
start to flow! Once you release your switch the bubbles will
stop.
5. When finished playing with Spider-Man Bubble Blower turn
him OFF to prevent battery drain.
Troubleshooting:
Problem: Spider-Man Bubble Blower does not function correctly.
Action #1: Check that all the batteries are installed, following
proper (+) & (-) polarity. Also check that all batteries are fresh.
Action #2: Replace the batteries paying close attention to proper
(+) and (-) battery polarity.
Action # 3: Make sure you have enough Bubble solution in the
bubble solution tank.
Action #4: Make sure that your switch is plugged into the jack all
the way. There should be NO gaps.
Action #5: Try your switch with another switch operated
toy/device in an effort to rule out your switch as the source of the
problems.
Care of Unit:
If you will not be using Spider-Man Bubble Blower for an
extended amount of time, we recommend removing the batteries.
Spider-Man Bubble Blower can be wiped clean with any
household multi-purpose cleaner and disinfectant. We
recommend Simple Green, which is a non toxic biodegradable
all-purpose cleaner.
Do not submerge the unit, as it will damage the contents and the
electrical components.
Do not use abrasive cleaners, as they will scratch the surface
of the unit.
Rev 3/26/2021
