Enabling Devices Baby Retriever User manual

For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
-9 4-747-3070 or -800-832-8697
[e-mail]
Baby Retriever #889
USER’S GUIDE
50 Broadway
Hawthorne, NY 0532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com

See pooch walk!
This adorable, lifelike little pup barks, wags his tail and swings
his head when his human playmate activates an external
capability switch (not included). A great cause and effect
experience. Si e: 6"L x 7"H. Requires Capability Switch and 2
AA Batteries. Weight: ½ lb.
Operation:
1. Baby Retriever requires 2 AA batteries (not included) to
operate. Alkaline batteries must be used (e.g. Duracell or
Energi er Brands). Do not use rechargeable batteries
because they supply a lower voltage and the unit may not
perform as well. Never mix old and new batteries together or
different brands or types together.
2. Turn Baby Retriever upside down to reveal the battery
compartment. Install 2 AA batteries, paying close attention to
proper battery polarity.
3. Replace the battery compartment cover and secure it.
Connect Baby Retriever to any external capability switch
(not included) via the jack located at the end of Baby
Retriever’s cord. Baby Retriever is equipped with a 1/8"
jack for use with external capability switches with a 1/8" plug.
Make sure to make a tight connection. There should be no
gaps.
4. Actuate your external capability switch and Baby Retriever
will spring to life! He will walk forward and bark.
5. Baby Retriever will remain on while the external capability
switch continues to be actuated. Once you release the
external capability switch, there will be a brief delay, and
then Baby Retriever will turn off.
Troubleshooting:
Problem: Baby Retriever does not function correctly.
Action #1: Replace the batteries paying close attention to
proper battery polarity.
Action #2: Make sure that the connection between the external
capability switch and the jack is TIGHT. There should be NO
gaps.
Action #3: Try your switch with another switch operated
toy/device in an effort to rule out your switch as the source of
the problems.
Care of Unit:
 Do not inhibit Mini Baby Retriever’s movement, as this may
cause irreversible damage.
 Do not lift Mini Baby Retriever up by his head, tail or legs, or
drop Baby Retriever.
 If you will not be using Baby Retriever for an extended
amount of time, we recommend removing the batteries.
Do not submerge the unit in water, as it will damage the
electrical components. Baby Retriever is surface washable only.
Rev /20/2023