Enabling Devices Bubble Hurricane 2239 User manual

Care of the Unit:
Care of the Unit:Care of the Unit:
Care of the Unit:
Hurricane Bubbles should be cleaned after each use following photo
diagram below.
Do not use
Do not useDo not use
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit, as it will damage the electrical
components.
For
For For
For echnical Support:
echnical Support:echnical Support:
echnical Support:
Call our echnical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (ES )
1-800-832-8697
[e-mail]
Bubble Hurricane #2239
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
el. 914.747.3070 / Fax [phone]
oll Free 800.832.8697
www.enablingdevices.com

A storm of bubbles!
A storm of bubbles!A storm of bubbles!
A storm of bubbles!
Activate your capability switch to create thousands of fun bubbles.
Great for developing tracking skills and for teaching cause and
effect. Comes with an 8 oz. bottle of bubble solution. Size: 11"W x
12½"H x 5½"D. Requires 6 AA Batteries. Weight: 1 ½ lbs.
O
OO
Operating instructions:
perating instructions:perating instructions:
perating instructions:
1. Hurricane Bubbles requires 6 AA batteries (Not included) to
operate. Alkaline batteries must be used only (e.g. Duracell or
Energizer brand). Do not use rechargeable batteries or any other
type of batteries because they supply lower voltage and the unit
will not perform properly. Never mix old, new or different types of
batteries together. Replace the battery compartment covers and
screws.
2. he battery compartment is located on the top of the unit. Lift up
on the left or right side of the cover. he cover plate will lift off.
Next using a Phillips head screw driver, remove the four small
Phillips head screws. Lift cover off install 6 AA batteries paying
close attention to proper (+) and (-) battery polarity.
3. Replace the battery compartment cover and screws. Connect
Hurricane Bubbles to any external capability switch (not
included) via the cord jack cord located at the back of the unit.
Hurricane Bubbles is equipped with a 1/8″ jack for use with
external capability switches with a 1/8″ plug. Make sure you
plug your switch all the way in. here should be no gaps.
4. You are now ready to fill your Hurricane Bubbles with bubble
solution. As shown in photo.
5. Actuate your external capability switch and the bubbles will start
to flow! Once you release your switch the bubbles will stop.
roubleshooting:
roubleshooting:roubleshooting:
roubleshooting:
Problem # 1:
Problem # 1: Problem # 1:
Problem # 1: Hurricane Bubbles does not turn on when switch is
depressed.
Action # 1:
Action # 1: Action # 1:
Action # 1: Make sure that you press all connections firmly together.
Any gaps may interrupt electrical connection.
Action # 2:
Action # 2: Action # 2:
Action # 2: Make sure batteries are fresh and installed properly.
Action # 3:
Action # 3: Action # 3:
Action # 3: ry a different switch with your Hurricane Bubbles to rule
Problem #2:
Problem #2: Problem #2:
Problem #2: Hurricane Bubbles does not blow bubbles.
Action:
Action:Action:
Action: Make sure you have bubble solution in the reservoir.
Rev
RevRev
Rev 4
44
4/
//
/7
77
7/17
/17/17
/17