Event Lighting CO2RGB User manual

CO2RGB
LED CO2 JET
USER MANUAL
For your safety, please read this user manual carefully before use.
Event Lighting reserves the right to revise the manual at any time. Information and specifications
within this manual are subject to change without notice. Event Lighting assumes no liability or
responsibility for any errors or omissions. Please consult Event Lighting for any clarification or
information regarding this item.
Version 1.0

www.event-lighting.com.au
1
Safety Instructions
CO2 blasts cannot exceed 10 seconds in length.
Two blasts cannot occur within 5 seconds of each other.
Connect power supply last.
Product Installation
1. Place the large CO2 column on the corresponding position.
2. Connect the CO2 hose to the gas bottle. Place the bottle upright on a secure surface.
3. Connect the CO2 hose to CO2RGB.
4. Turn on the valve on the gas bottle.
5. Connect CO2RGB to the console.
Before disassembling, turn off the valve and release any gas remaining in the pipe before turning
off the power and disconnecting the hoses.
DMX Chart
Channel
Value
Function
1
000-255
CO2 Spray
2
000-255
LED Colour Mixing
3
000-255
Red: 0% ~ 100%
4
000-255
Green: 0% ~ 100%
5
000-255
Blue: 0% ~ 100%
6
000-255
Strobe, increasing in speed.
Technical Specifications
Input Voltage: 110-220V AC 50/60Hz.
Power Consumption: 250W.
Control: DMX512.
DMX Channels: 6.
LED Colours: R/G/B/Mixed.
Spray height: 8-10 metres, depending on humidity.
Pressure Rating: Up to 1,400psi (96 bar)
Dimensions: 300x300x420 mm
Weight: 9kg
Warranty
Please refer to your local dealer or contact Event Lighting.