Heat & Glo LOGS-SL750TRS-D User manual

Heat & Glo • SL-750TRS-IPI-D • 2066-935 Rev. E • 9/06
Log Set Assembly: LOGS-SL750TRS-D
Model: SL-750TRS-IPI-D LOG PLACEMENT
INSTRUCTIONS
STEP 1.
CAUTION: Logs are fragile!
Carefully remove the logs from the packaging.
LOG NOTCHES
STEP 2.
LOG #1 (SRV2065-701) Place log #1 on left flat side of
the burner assembly. Pull the log forward and slide it to
the right until the notches under the log are in the burner
grooves.
STEP 3.
LOG #2 (SRV2066-702) Place log #2 on the grate bar
and push it back against refractory. The pilot should be
centered within the large notch on log #2.
1
1
2
2
3
3
4
4
5
5
1
1
2
2
1
1

Heat & Glo • SL-750TRS-IPI-D • 2066-935 Rev. E • 9/06
STEP 4.
LOG #3 (SRV2066-703) Place log #3 on right side of
grate. The notch on the log should fit over the bar on the
far right side of the grate. Push the right side of log #3
against the grate tab and pull the left side forward until
it comes into contact with the burner detail as shown in
Figure 1.
STEP 5.
LOG #4 (SRV2066-704) Place log #4 so that the notch
is touching the first grate tine and is laying in the flat spot
of log #2. The right end of log #4 should touch the back
refractory panel. See Figure 2.
STEP 6.
LOG #5 (SRV2066-705) Place log #5 on log #2. The
front left of the log will rest on log #4. Log #5 must be
pushed back against refractory. See Figure 3.
1
1
2
2
3
3
4
4
2
2
1
1
2
2
3
3
5
5
3
3
4
4
1
1
NOTCH
Figure 2.
Figure 3.
NOTCH
LOG TOUCHES REFRACTORY PANEL
Figure 1.
LOG/BURNER DETAIL CONTACT AREA
LOG #5/REFRACTORY PANEL CONTACT POINTS