Heat & Glo LOGS-SL550TRS-D User manual

Heat & Glo • SL-550TRS-IPI-D • 2065-935 Rev. E • 9/06
Log Set Assembly: LOGS-SL550TRS-D
Model: SL-550TRS-IPI-D LOG PLACEMENT
INSTRUCTIONS
STEP 1.
CAUTION: Logs are fragile!
Carefully remove the logs from the packaging.
1
1
2
2
STEP 2.
LOG #1 (SRV2065-701) Place log #1 on left flat side of
the burner assembly. Pull the log and slide it to the right
until the notches under the log are in the burner grooves.
STEP 3.
LOG #2 (SRV2065-702) Place log #2 on the grate bar
and push it back against the refractory. The pilot should
be centered within the large notch on log #2.
LOG NOTCHES
1
1
1
1
2
2
3
3
5
5
4
4

Heat & Glo • SL-550TRS-IPI-D • 2065-935 Rev. E • 9/06
STEP 4.
LOG #3 (SRV2065-703) Place log #3 on right side of
grate. The notch on the log should fit over the bar on the
far right side of the grate. Push the right side of log #3
against the grate tab and pull the left side forward until
it comes into contact wiht the burner detail as shown in
Figure 1.
LOG NOTCHES
STEP 5.
LOG #4 (SRV2065-704) Place log #4 so that the notch
is touching the first grate tine and is laying in the flat spot
of log #2. The right end of log #4 should touch the back
refractory panel. See Figure 2.
STEP 6.
LOG #5 (SRV2065-705) Place log #5 on log #2. The
front left of the log will rest on log #4. Log 5 must be
pushed back against refractory. See Figure 3.
3
3
1
1
2
2
4
4
3
3
2
2
5
5
1
1
1
1
2
2
3
3
4
4
Figure 1.
Figure 2.
Figure 3.
LOG/BURNER DETAIL CONTACT AREA
LOG TOUCHES REFRACTORY PANEL
NOTCH
LOG #5/REFRACTORY PANEL CONTACT POINTS