JSI Flux User manual

Installation Instructions
Attaching Run-off Desk with End Panel to a Support Credenza
Credenza Type
Page 1 of 2
Flux
Hardware Used
Level
#8 x 7/8”Wood Screws
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL012
1-23-18
Product Layout Plan
Phillips Head BitScrew Gun
Screw Driver
Recommended Tools
Pencil
Tape Measure
Drill Bit
Flat Bracket
four (4) brackets
included
Step 1 Attaching the Flat Brackets
• Determine the location (from the plan)for the
run-off desk. Make sure
credenza is level and placed correct in the
layout location.
• Evenly space out a bracket locations provided
with run-off desk. The flat bracket should be
centered half way between the bracket length.
recommended one brackets be
located in front of the standard modesty
panel.
• See diagram A for flat bracket spacing .
• Fasten the flat bracket to the credenza using
the provided screws, #8 x 7/8 ”.
Diagram A

Installation Instructions
Page 2 of 2
Flux
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL012
1/23/11
Step 3 Attaching Run-off Desk
• Lift the run-off desk in to place, using the bracket on
the credenza as support.
• Measure the location and level the run-off desk.
• Lift the run-off desk in to place, align the holes and
fasten the brackets to underside of the run-off desk
with the provided screws, #8 x 7/8 ”as shown in
the diagram.
• Fasten three 90°angle brackets at the corner of the
modesty panel (see diagram B) in the interior of the
unit to the wing end panel of the credenza and the
top of the credenza by using the screw provided,
#8 x7/8 ” screws.
Attaching Run-off Desk with End Panel to a Support Credenza continued
Diagram B