HunterDouglas 5-151 User manual

REV 01 August`11
Type 5-151
Installation Instruction
Duo Roller Blind (Fascia)
Clutch Operation

a
b
click
2
1
click
click
2
1
c
8
1 2
3 4
5 6 9 10
7
14
12 13
11
REV 01 August`11
Place the clutch (with short chain) in the bracket 1
and slide it down until it clicks 2.
Fix the brackets with the screws provided.
a recess b wall c ceiling
Place the tube adapter on the clutch head of upper
roller blind. Press the bearing and lift the blind ...
... until it snaps into the bracket. If there is no leveller
option you can continue with installing of the lower
blind the same way as the upper blind.
Installation
Option: Leveller
Place the leveller on the bearing side in the brack-
et. Make sure that the opening for the Allen key is
pointing downwards. Turn the leveller until it clicks.
To adjust skewing, put the provided Allen key into
the screw of the leveller and turn it left or right to
move the blind up or down. Support lifting of large
heavy blinds with the palm of your hand.
Turn the upper clutch (with long chain) 30° and
place it in the bracket and slide it down until it clicks.
Place the chain from the upper clutch into the chain
outlet set. Fold the chain outlet set together until it

holes. Pay attention that L or R indicates inside.
Fix the chain outlet set with the screws provided.

click
1
2
2
1
1
1615
17
18
19 20
22
21
25 26
24
23
REV 01 August`11
123



Slide the end caps onto the brackets.Install the lower leveller and roller blind after hori-
zontal adjusting of the upper blind. The integrated
leveller is already installed in the bracket.
Slide a screw driver between bearing plug and
bracket and push the bearing in the clutch direc-
tion.
Place the screw driver under the end cap, turn
the screw driver and slide the end cap from the
bracket.

and pull it outwards (2).
Removal
Move the blind downwards out of the bracket.
Outside: Push the pin of the clutch and take the
clutch out of the bracket. Loosen the screws of the
chain outlet set and remove the upper clutch in the
same way.

27 28
REV 01 August`11
12
3
Inside: Place a screw driver under the pin of the
clutch and pull it outwards. Take the clutch out of
the bracket. Loosen the screws of the chain outlet
set and remove the upper clutch in the same way.