INNOVAPLAS WALK WAY User manual

WALK WAY DECK ASSEMBLY
Required tools (not included)
WARNING
Do not dive or jump from the step or ladder.
Use BATTERY operated tools to avoid electric shocks.
Install step on flat surface, following the manufacturers
instructions .
Remove step from pool during freezing climate season.
Manufacturer cannot be held responsible for injuries caused
by abusive use of product.
Ask your city about specific regulations that apply to your
above-ground pool and ladder.
Use small locking
pliers / vice grip
or a wrench 7/16''
Sand
15 lbs
(Not included )
Sand
Contents of Accessory box # 955-014
x2
x2
x4
x4
105-012
105-005
x4 x4
115-010
115-015 (1 1/2 in.)
x8
x18
115-014 (3/4 in.)
115-018 (2 1/2 in.)
x2
SCREW BAG 140-059
x2
Walk Way Step
x1
x1
x4
REV: 10/02/10 PG. 1
A
1) Flip the Walk Way
so that the steps
are directly facing
the ground.
2) Place the
support tube,
one side at a time,
in the pockets located
in the bottom lip.
3) Flip the step back
to its original usage
position.
4) Secure the support
tube to the step with
the screws provided.
115-014 (3/4 IN.)
x2
PN: 110-106
250 Industriel Blv,
St-Germain, (Québec),
Canada J0C1K0

PN: 110-106
MANUFACTURER
WARRANTY
1 Year on the step.
1 year on the hardware.
To prevent a
pool liner
puncture, keep
a minimum of 1"
inch gap between
the pool liner
and the rear
underside of
the step.
WARNING
2) Insert the deck
arms over the 2 rear
posts. Do not secure.
3) Insert the post
covers into the large
handrails and secure
the handrails to the
posts with the
screws
provided.
x8
115-014 (3/4 in.)
x4
105-012
105-005
x4 x4
115-010
1) Insert the entire step into the pool.
Be careful not to damage the pool liner.
115-015 (1 1/2 IN.)
115-014 (3/4 IN.)
115-018 (2 1/2 IN.)
x4
x8
x2
1) Secure the deck
arms to the deck using
the screws provided.
2 ) Secure the deck arms
to the posts with the
screws provided.
MINIMUM OF 1"
PG. 2
2) Slide the deck arms to
the height of the deck.
1) Insert the four posts
into the step. Secure
the posts in place
with the bolts,washers
and nuts provided.
REV: 10/02/10
x4
1) Snap the suction
cups into the 4 holes
under the step. Push
while twisting, till the
upper cup mushroom
has cleared the wall
thickness of the step.
Sand
X4
115-014 (3/4 in.)
250 Industriel Blv,
St-Germain, (Québec),
Canada J0C1K0
1) Fill the
counterweight to
the brim with sand.
2) Secure the
counterweight
cover with the
screws provided.
C
B
EF
D