KI WireWorks Base Raceway Center Support User manual

Important: Electrical wireway
must be removed prior to
installation of center support
bracket.
1. Position raceway center support
near the center of the panel under
the lowest steel horizontal as
shown below. Make sure the
larger leg of the bracket is
towards the top (Figure 1).
2. Slide the support into the open-
ing of the horizontal (Figure 2).
Note: Raceway side door
removed for clarity.
Assembly Instructions
WireWorks®Base Raceway Center Support
August 2004
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
1330 Bellevue Street • P. O. Box 8100 • Green Bay, WI 54308-8100 • Tel [phone] • www.ki.com
© 2004 KI All Rights Reserved • Litho in USA • Code KI-61594R2/TM/GT/1004
Figure 1
Figure 2
center support
steel horizontal

3. Rotate the bracket 90° to engage
it into the steel horizontal and the
base raceway. The center of the
raceway is now supported
(Figure 3).
Note: Raceway side door
removed for clarity.
4. Cut a small notch in the base
raceway door as shown. This
provides clearance and allows
the door to close completely
(Figure 4).
Note: Steel horizontal not
shown.
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
WireWorks Base Raceway Center Support
Assembly Instructions
Figure 3
Figure 4
cut a notch
base raceway