Komet EndoPilot User manual

EndoPilot
Step-by-Step Setup Guide

2
Plug in the green plug of the apex locator cable (9) to the color-coded port on the right side of the EndoPilot.
Then plug the file clip connector cable (8) into the end of the apex plug.
1
Make sure that you have all of the required EndoPilot components.
Components:
1EndoPilot control unit
2Wireless remote foot switch
3Handpiece motor’s (blue plug)
4Contra-angle
5File clip holder
6Lip clip
7File clip
8File clip connector cable
9Apex locator cable (green plug)
1
2
3 4 6
7
5
8
9

AK AN
3
Plug the black file clip (7) into the other end of the connector cable (8) and then plug the lip clip (6) into the
remaining end of the apex cord (9).
4
Plug the EndoPilot Handpiece motor’s (3) blue plug into the blue receptacle on the right side of the EndoPilot,
then connect the contra-angle (4) to the handpiece.
5
Turn on the EndoPilot using the power button located on the rear of the device. Plug in your EndoPilot and if battery
indicator on the touchscreen reads less than 80%, plug in the charging cable and wait until indicator is over 80%.

Komet USA LLC · 3042 Southcross Blvd, Suite 101 · Rock Hill · SC 29730 · USA · Phone [phone] · Fax [phone] · [email protected] · www.kometusa.com
© Komet USA LLC · 02/2021 · 10009668v.001
For further information
on the EndoPilot
6
Calibrate the Motor — from the Home Screen, Select Treatment, then on the treatment screen, select the options
button (it looks like a gear in the upper right corner). Then select “Calibrate”. For optimal results the EndoPilot
should be calibrated daily.
7
X-out – Select File System and start your treatment