LCN ST-2701 User manual

*27176*
27176
© Allegion 2014
Printed in U.S.A.
27176 Rev. 01/14-b
WARNING
Do not remove spring tube from this product. Extremely
strong springs inside. If repairs are necessary, return to
factory.
1
Mount closer body in pocket according to dimensions shown on
template. Wall of pocket must be reinforced to ensure mounting of
body.
2
Mount rod and shoe on door according to dimensions shown on
template.
3
Place arm on closer shaft with main arm 35°to closer body (see
illustration). Do not rotate closer shaft. Secure arm to shaft with
arm screw.
4
With door in closed position:
1. Pull closer main arm away from door.
2. Slowly release arm and insert rod into forearm (see
illustration).
5
Adjust arm to form slightly less than a 90°angle with door in
closed position. Secure with arm set screw. (see illustration)
6
Slowly open door into pocket. DO NOT FORCE if door will not
open completely. If door will not open completely into pocket,
adjust arm as shown in below illustrations.
Customer Service
1-877-671-7011 www.allegion.com/us
This product is not intended for use with conventional hinges or latching devices.
ST-2701
Installation Instructions

7
Closing speed adjustment.
CAUTION
Improper installation or regulation may result in personal
injury or property damage.
LImportant
• Regulation: Do not allow door to slam into frame. A “normal” closing time from 90°open position is 5 to 7 seconds, evenly divided
between main swing speed and latch swing speed. Use socket key furnished to adjust speed. To slow main speed of door, turn
regulating screw nearest shaft clockwise. To slow latch speed, turn regulating screw nearest latch clockwise.
• Backcheck: To increase backcheck intensity turn regulating screw farthest from hinge clockwise.
LDO NOT USE ABRUPT BACKHECK
8
Mount cover on closer body and secure with two cover screws. Tighten screws rmly.
9
If closing power needs to be increased, shim closer out from wall to a minimum 2 Z\x” pocket depth. This will provide an extra Z\x pound of
closing force at latch.