Nav TV OPV-2BMW User manual

OPV-2BMW
VIDEO IN MOTION & A/V INPUT
BMW 1 / 3 / 5 / 6, NEW X5 / X6 & MINI
(iDrive)
With TV Tuner
From the main menu of the car system you will
need to select TV then supply 12V+ to the
BLUE switch cable (e.g. connect to remote out
from DVD) to switch audio and video to your
new external source. The switch wire will then
need to be deactivated when you revert back
to any of the other functions if you wish to lis-
ten to the audio from another factory source.
The “video in motion” feature can be de-
activated (and activated) by pressing and
holding the “track down” button on the car
steering wheel controls (not MINI). When de-
activated you will have the factory safety mes-
sage as shown below.
OPERATING INSTRUCTIONS

The interface is installed at the DVD / Nav-
igation unit located in the front of the vehi-
cle below the screen.
To remove the Navigation unit you will need to
remove the trim that houses the two main air
vents (1) (trim clips only, 6 series has 1
screw behind the hazard switch) then
remove 2 screws holding the centre trim that
surrounds the navigation unit (2). The trim will
then come away (trim clips only) Next remove
the screws holding the unit.
LOCATION & REMOVAL
OPV-2BMW (CAN)
Plug the interface into the corresponding 8
way plug and mount.
OPV-2BMW (MOST)
Plug the interface into the corresponding 12
way plug and mount.
Connect your VIDEO source to the YELLOW
Phono socket.
Connect your AUDIO source to the RED &
BLACK Phono sockets.
Connect the BLUE cable to a suitable 12v+ or
remote out to activate your new added A/V
source.
INSTALLATION
(1)
(2)
INSTALLATION
Remove the “Quadlock” connector (fig01)
from the unit and remove the optical plug from
the position shown (fig01) plug the “Quadlock”
into the supplied harness, then plug the
supplied harness into the unit.
Next remove the small blue locking tab from
the optical plug and pull the OUT (2) cable out
of the plug. Connect this cable to the OUT (2)
cable of the supplied optical harness using the
black joiner. Now insert the IN (1) cable from
the supplied optical harness into the OUT (2)
socket of the factory optical plug. Insert the
factory optical plug into the supplied
“Quadlock” at the position shown in (fig01)
Fig01