Nav TV NAV-INREN User manual

NAV-INREN
VIDEO INPUT
ALL Renault
With Separate Navigation
OPERATING INSTRUCTIONS
VIDEO2 (Camera Input) is activated when the
Blue cable is made live (adding a 12v+
supply) This input will override the additional
source (VIDEO1) or the navigation map when
activated.
If VIDEO 1 is required you will need to CUT
the ORANGE cable on the harness and add in
an external switch. When the orange cable is
broken the VIDEO 1 source will be activated.
When re-connected the factory Navigation will
be restored.

LOCATION & REMOVAL INSTALLATION
Locate the cable which connects the
Navigation computer with the monitor. Within
this cable you will find the cable colours given
below You will then need to cut open the these
cables and connect the input and output
cables from the supplied harness as the dia-
gram opposite shows.
The following colours can be found in the screen to
navigation cable.
NAV-INREN Car Harness
RED to RED
GREEN to GREEN
BLUE to YELLOW
YELLOW to BLACK
Shield to Shield/GND
Inside the interface the jumper should be at the shown
position
1. Ensure the vehicle is equipped with Nav-
igation
2. All the wires can be accessed at the
connector on the back of the navigation.
NAV (Input)
SCREEN (Out) 16 15 14 13 12 11 10 9
8 7 6 5 4 3 2 1
Rear of plug
INSTALLATION
For Velsatis model
NAV-INREN Car Harness
RED to RED
GREEN to GREEN
BLUE to ORANGE
YELLOW NOT USED
Shield to shield/GND
Inside the interface the jumper should be at the shown
position
Other connections
YELLOW to 12v+ ignition / acc
BLACK to 12v– Ground
BLUE to 12v+ to activate VIDEO 2
ORANGE Cut and add switch for VIDEO 1
1 2
The RGB switch should be set to
RGBS
The RGB switch should be set to
RGSB