Neousys Technology SEMIL-1700 Series User manual

SEMIL-1700 Series
Quick Installation Guide
• Only qualified service personnel should install and service this
product to avoid injury.
• Observe all ESD procedures during installation to avoid damaging
the equipment.
Unpack the equipment and make sure the following tools are
available and delivered contents are correct before you begin the
installation procedure.
1-1. User-provided tools
1-2. Packing List
• Anti-static wrist wrap
1Preparing tools
2
USB Port
Warning
01
02
SEMIL 1700 series system
Drivers & utilities disc
1
1
Item Description Quantity
Overview 3DC-IN
4PoE+ Gigabit Ethernet Port 5
Please make sure the voltage of DC power is correct before you connect
it to the system. Supplying a voltage over 48V will damage the system.
Warning
VGA Port
6
The number of ports for each SEMIL-1700 model variant is listed below:
(Optional)

Port COM
7 Power Button
9
The power button is a non-latched switch for ATX mode
on/off operation. To turn on the system, press the power
button and the PWR LED should light-up green. To turn off
the system, issuing a shutdown command in OS is
preferred, or you can simply press the power button. To
force shutdown when the system freezes, press and hold
the power button for 5 seconds. Please note that there is a
5-second interval between on/off operations (i.e. once the
system is turned off, there is a 5-second wait before you
can power-on the system).
Audio Port 8
7
Pin Definition
Panel side Cable connector end
The system provides two COM ports via an M12 A-coded connector for
communicating with external devices. These COM ports are 3-wire RS-
232 specifications and provide up to 115200 bps baud rate.