Opus cityLAM A4 User manual

User’s manual
OPUS cityLAM A4
6
User’s guide OPUS cityLAM A4

User’s guide OPUS cityLAM A4
Healht & Safety precautions:
● BeforeoperatingtheequipmentpleasereadtheHealth&Safetyprecautions,manufacturer
recommendationsandtheoperationmanual.
● Theoperationmanualshouldbeeasilyavailableatanytimefortheoperator.
● Theequipmentshouldbeinstalledonsturdyandlevelsurfaceneara220-240V,50Hzsocket.
● Theequipmentshouldbeprotectedagainstdustandmoisture
● Theequipmentmustnotbeplacedneartheheatingorventilationunits.
● Theequipmentmustnotbeusedinvicinityofinflammableliquidsorgases
● Thepowersupplycableshouldbeprotectedagainstdamageandmustnotbeusedtopullthe
equipmentortoremovetheplugfromthesocket.
● Theequipmentmustbekeptawayandoutoffromreachofchildren.
● Danger!Theequipmentcontainsrotaryelements.Ensurelonghair,loosejewellery,tiesandother
loosepiecesofclothingarekeepawaytheycanbegetentangledintherolls.
● Theequipmentmustnotbeusedforanyotherpurposesthanthoseindicatedintheinstruction
manual.
● Itisnecessarytocheckandsuperviseiftheequipmentisoperatedcorrectly.
● Incaseofanymalfunctions,youmustcontactthedealerorserviceteam.
● Theequipmentmustnotbelocatedoutsideandshouldbeoperatedinaroomtemperaturehigher
than+8°C.
● Beforeremovinganycoversfromtheequipment,removethepowerplugfromamainssocket.
● Usinginappropriatelubricantscausesafirehazard.
● Anyrepairsmustbecarryoutonlybyauthorisedstaff.
● TheequipmentmustbeoperatedaccordingtogeneralHealth&Safetyrules.
● Donotleavetheequipmentinoperationwithoutanoperator.
● Afterworkitisnecessarytoturntheequipmentoffbytheswitchonunitafterthecoolingdown
procedure,nextremovetheplugfromasocket
Manufacturer’s recommendations:
● Useonlyrecommendedsuppliesandaccessories.
● Donotputintothelaminatordocumentsthickerthan1mm.Thelaminatedmaterialshouldalways
havesimilarproperties
● Removethemainsplugfromthesocketbeforemovingtheequipmentorduringlongernone
operation.
● Iftheequipmentisswitchedonandisnotoperatedformorethanonehour,itcanbeoverheated.
Toavoidbadqualitylaminationput2or3sheetofA4paperthroughinordertocooltherollers
down
● Alwaysinsertthelaminatingpouchwiththecloseendintothelaminatorfirst.Puttingtheopen
endfirstcancausebubblingandthefilmbeingstuckontherollersinsidethelaminator.
● Incaseofadocumentbeingstuckinsidethelaminator,usereversefunctionREVswitch.
● Tailorcutpouchcanmaketherollersstickyanddirtyandwindroundthemuseacarrier.
● Removeallmetalelements(staples&paperclips,etc.)beforelaminatingthedocument.
● NOTE! The equipment contains heater elements, be aware high temperatures!
● NOTE! Not compliance with the rules and recommendations above can void the
Guarantee/Warranty.
7

User’s guide OPUS cityLAM A4
8
Operation:
1.Startingtheequipment:
•Plugtheequipmentintothepowersocketandturnonbypressingthebutton
•Pressthebuttonsonthetouchpaneltosetupthethicknessofpouchrequiredfromtherange
offoilthicknessesfrom80mic–200mic.Theprocessofheatingwillstartautomatically.
•Theheatingtimeforthelaminatorrollersis4-6minutes.duringthistimeonLCDdisplaythe
reddiode.
•Whenlaminatorisreadythegreendiodeflashes.Theequipmentisnowreadytouse.
2.Preparingthedocument:
•Choosecorrectthicknessandtypeofpouch.Putthedocumentintothepouch.
NOTE! It is recommended to leave approx. 3mm margins all around the document
from the edge.
3.Hotlamination
•Opentheflapatthebackofequipment,insertthelaminatingpouchfromthefrontwiththe
documentinsideitintotherollers,andremembertoputthesealedendfirst.
•Thepouch/documentwillmovethroughtheunitandexitattheback.
•Ifthelaminationisnotgoodyoucanrepeatlaminatingorchangesettings
•Afteronehourin“standby”modethemachinewillturnoffautomatically
4.Coldlamination
•Plugtheequipmentintothepowersocketandturnonbypressingthebutton.Chooseproper
optionondisplayfor„coldlamination”
•Afterhotlaminationwait40-60mintocooldowntheequipmentbeforeyoustarttocoldlaminate.
Maintenance and service:
•Beforeclearingtheequipment,removethepowerplugfromthesocket.
•Ifthepouchwasentangledintotherollersorthelaminatordoesnotoperatecorrectlycontact
thedealerorserviceteam

5
Instrukcja obsługi laminatora OPUS cityLAM A4
Declaration of Conformity
Deklaracja Zgodności
OPUS Sp.z o.o. hereby declares that the machine specied below is in
accordance with the following directives and standards:
Opus Sp.zo.o. deklaruje z pełną odpowiedzialnością, że urządzenie, którego
dotyczy niniejsza deklaracja jest zgodne z postanowieniami następujących
dyrektyw UE oraz powiązanymi z nimi normami zharmonizowanymi:
2006/95/WE; 2004/108/WE
EN60950-1:2006+A12:2011 ; EN55014-1/A1:2009; EN55014-2/A2:2009;
EN61000-3-2/A2:2009; EN61000-3-3:2008
Name/ Nazwa: OPUS Sp. z o. o.
Address/ Adres: ul. Toruńska 8
44-122 Gliwice
Type of the machine / typ: Laminator
Model No / model: cityLAM A4
POLAND / Polska …………………………………
(Place) (Signature)
01.01.2013 Krystian Nawrat
(Date) (Full Name)
1
0
0
%
Z
Á
R
U
K
A
1
0
0
%
Z
Á
R
U
K
A
MùSÍCE
JISTOTA KVALITY
MùSÍCÒ
¤EZNÉ NO˛E
¤EZNÉ NO˛E

9
User’s guide OPUS cityLAM A4
Technical data:
Heatingsystem:    4rollers
Preheatingtime:    4-6minutes
Recommendedpouchthickness:  80-200mic
Maxdocumentthickness:   1mm*
Laminatingwidth:    235mm
LaminatingSpeed:    360/420mm/min(50/60Hz)
Powervoltage:    AC220-240V/50/60Hz
Power:     350W
Ratedcurrent:    1,5A
Dimensions(WxDxH):   375x150x105mm
Netweight:    2,7kg
* dokument wraz z folią laminacyjną
14.11.2012