Outdoor GreatRoom Company DIY-2032 Instruction manual

90246 REV C 6/10/13 1
DIY Gas Fire Pits
Assembly and Installation instructions for Natural Gas DIY-38, DIY-2032, DIY-2049
Thank you for purchasing a Do-It-Yourself gas fire pit kit from The Outdoor GreatRoom Company. Please read through all
instruction steps and warnings before assembling your fire pit.
Included in your DIY kit
DIY-2032 (Rectangular)
DIY-2049 (Long Rectangular)
DIY-38 (Round)
Burner
Electronic igniter
Metal flex hose
4-piece DIY burner support
(8) Nut, bolt , lock washer
(2) Black #6 –5/8” screws
#31 Orifice (NG)
#43 Orifice (LP)
Control panel with mounting
bracket and optional filler.
Grounding wire
Sparker extension wire
Burner
Electronic igniter
Metal flex hose
6-piece DIY burner support
(12) Nut, bolt , lock washer
(2) Black #6 –5/8” screws
#21 Orifice (NG)
#31 Orifice (LP Over 100lb tank)
Control panel with mounting
bracket and optional filler.
Grounding wire
Sparker extension wire
Burner
Electronic igniter
Metal flex hose
4-piece DIY burner support
(8) Nut, bolt , lock washer
(2) Black #6 –5/8” screws
#17 Orifice (NG)
#36 Orifice (LP over 100lb tank)
Control panel with mounting
bracket and optional filler.
Grounding wire
Sparker extension wire
Recommended tools and supplies
2 adjustable wrenches for tightening gas connections
7/16” wrench for assembling burner support
Power drill with Phillips bit
AAA Battery for igniter (not included)
Lava rock or other decorative media* (sold separately)
Masonry block
Outdoor-rated construction adhesive for securing block and control panel (if desired)
Leveling device for placing block
Concrete chisel
¼” concrete anchors (optional for attaching control panel bracket to block)
Hammer drill (for drilling holes for concrete anchors)
*lava rock, heat-tempered glass, or other decorative fire-safe medium MUST be used to ensure proper
burner operation. Do not burn without covering burner with lava rock or similar.
Consult your Crystal Fire Owner’s manual included in
this kit for important safety and other information
before operating this burner.
NOTE: If using a 20lb propane tank, an LP kit is available for purchase
on page 5 of this instruction booklet.
Dimensions for recommended
fire pit sizing located on page 5
GAS-FIRED

90246 REV C 6/10/13 2
Step 1: Assembling the burner support
Step 2: Installing the Control Panel (suggested method for common cases)
Filler (optional) for taller
blocks
Insert
AAA battery
(not included)
Control panel front can
be removed in the
future for access to gas
valve and maintenance.
DIY-38 DIY-2032 DIY-2049

90246 REV C 6/10/13 3
While the control panel included in your kit is meant to work universally for most fire pit block sizes, for
extreme cases, blocks may need to be cut to ensure a perfect fit. See below for installation methods.
Step 3: Placing the control panel (suggested method for common cases)
Option 1:
For smaller block sizes
Option 2:
For larger block sizes
For rectangular DIY fire pits, blocks should be cut to size for proper fit. Alternatively, mesh
screen or other material can be cut and attached to control panel to act as filler around control
panel.
Control panel assembly should be
glued or secured with ¼” concrete
anchors to the block below it.
Be sure to locate the
sparker electrode and
burner neck facing toward
control panel
Cut hole, remove material with
chisel, or leave gap between blocks
for incoming gas if needed.
Burner support ring should be
located one block layer above
control panel. (a longer flex-
line can be used if mounting
control panel elsewhere)
8” minimum clearance to
combustibles below burner
Space or cut blocks to
provide adequate
airflow under the
burner in case of a gas
leak. 10 square inches
total of ventilation is
required at ground
level.
Always follow local codes and block manufacturer suggestions
for building a safe block fire pit.

90246 REV C 6/10/13 4
Step 4: Making Connections
Follow the steps below for making proper grounding, ignition, and gas line
connections.
Connect grounding wire to sparker
box as shown.
Gas input from source
When hooking up gas to burner, be sure to turn off gas flow at the source
(by closing valve on propane tank or natural gas line) before making any
connections. Tighten all gas connections securely using two wrenches
ENSURE THAT GAS LINES ARE NOT TOUCHING THE UNDERSIDE OF THE
BURNER WHILE IN OPERATION. THIS SURFACE CAN GET VERY HOT.
SECURE ALL GAS LINES AWAY FROM BURNER WHENEVER POSSIBLE.
CONSULT YOUR CRYSTAL FIRE OWNER’S MANUAL FOR MORE
IMPORTANT SAFETY INFORMATION
Plug the black sparker wire into the igniter box. A sparker wire extender is
included in your kit if the burner’s wire does not reach your control panel location.
Metal Flex
hose to burner
Note: Some burner models
may include a second
(orange) wire. This is not
used for this installation
Not used
Screw large end of orifice into burner neck. Orifice size should match the gas type
being used. See page 1 for info.
Air shutter should be in the closed
position (No screen showing) for
natural gas, open 1/8” for propane gas.

90246 REV C 6/10/13 5
With gas hookups completed and burner installed, install remaining layers of block
and secure with construction adhesive .
Scatter a layer of lava rock or other fire-safe material covering the burner and
surrounding area to create a natural looking fire pit. Decorative gas log sets and
high-temperature glass fire gems can also be purchased from
The Outdoor GreatRoom Company at OutdoorRooms.com
DIY-38
DIY-2032
DIY-2049
Fire Pit Dimension Ranges (dimensions given refer to range of interior dimensions that can be used to
create a fire pit. Exterior dimensions will be determined by block sizing)

90246 REV C 6/10/13 6
Using your DIY fire pit is simple. Just follow these easy steps and you’ll be enjoying your fire in no time!
Service and Optional Parts
Part Description
Part Number
Includes
20 lb propane conversion kit
DIY-LPK
#43 LP Orifice, 10ft Propane hose with regulator
Heat tempered glass fire gems
CFG-D
One 4lb bag of glass fire gems
(8 bags recommended for DIY-2032, 13 bags for
DIY-2049, 14 bags for DIY-38)
Black Lava rock
LAV-BK
.5 cubic foot bag of black natural lava rock
(2 bags recommended)
Log set for DIY-38,-2032, -2049
CF20-Logs
Decorative log set for DIY-38 or DIY 2032.
2 Sets required for DIY-2049
Electronic igniter
CF-Sparker
One piezoelectric igniter
Electrode and grounding wire
CF-Electrode
Sparker electrode and gounding wire for DIY
burners.
Replacement Control Panel Kit
DIY-
CONTROL
PANEL-KIT
Control panel, Control panel height extender, gas
valve. 2 black screws
Step 5: Operating the Fire Pit
1. Press and hold
sparker button.
Ensure it is sparking.
2. Push and turn
control knob to “ON”
to begin gas flow.
off
On
To Extinguish: Simply push and turn gas valve to “OFF” position .
Gas should be turned off at the source when not in use or while performing maintenance.
For more information about our products, visit us online at
http://www.OutdoorRooms.com
Or call us at: 1-866-303-4028

90246 REV C 6/10/13 7
The Outdoor GreatRoom Company extends the following warranty for Outdoor GreatRoom
outdoor products used in the United States of America or Canada. Dealers and employees of The
Outdoor GreatRoom Company have no authority to make any warranty or authorize any remedies
in addition to or inconsistent with the terms of this warranty. This warranty gives you specific legal
rights. You may also have other rights that vary from state to state.
The Outdoor GreatRoom Company warrants that this Outdoor GreatRoom Outdoor Product
(the “Product”) will be free from defects in material and workmanship for a period of one year from
its date of purchase. Stainless steel parts and assemblies carry a limited lifetime warranty. This war-
ranty is subject to the conditions, exclusions and limitations described below.
This warranty applies only to the original owner of the Product and is non-transferable. The Outdoor
GreatRoom Company obligation under this warranty does not extend to damages resulting from (1)
assembly, operation or maintenance of the Product not in accordance with the Installation/Assembly
Instructions, Operating Instructions and the Listing Agency Identification Label furnished with the
Product; (2) installation or use which does not comply with local building codes and ordinances;
(3) shipping, improper handling, improper operation, abuse, misuse, accident or unworkmanlike
repairs; (4) use of fuels other than those specified in the Operating Instructions; (5) Installation or use
of components not supplied with the Product or any other components not expressly authorized and
approved in writing by The Outdoor GreatRoom Company; and/or (6) modification of the Product
not expressly authorized and approved in writing by The Outdoor GreatRoom Company. Any of the
circumstances described in the previous sentence voids this warranty. This warranty is void if the
Product or any component has been removed, repaired, or replaced before The Outdoor GreatRoom
Company has been afforded a reasonable opportunity to inspect the Product.
This warranty is limited to the replacement or repair of defective components or workmanship and
The Outdoor GreatRoom Company may fully discharge its obligations under this warranty by
repairing or replacing, at its discretion, the defective components. The Outdoor GreatRoom
Company will provide replacement parts at no charge and will pay reasonable and necessary labor
and freight costs related to replacing or repairing defective components under this warranty. The
maximum amount recoverable under this warranty is limited to the purchase price of the Product
and, if The Outdoor GreatRoom Company is unable to provide replacement or repair in an
expedient and cost-effective manner, The Outdoor GreatRoom Company may discharge all
obligations under this warranty by refunding the purchase price of the Product.
EXCEPT TO THE EXTENT PROVIDED BY LAW, THE OUTDOOR GREATROOM COMPANY
MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSED HEREIN. THE
DURATION OF ANY IMPLIED WARRANTY IS LIMITED TO THE DURATION OF THE WARRANTY
SPECIFIED ABOVE. IN NO EVENT SHALL THE OUTDOOR GREATROOM COMPANY BE LIABLE
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY DEFECTS IN THE
PRODUCT. Some states do not allow limitations on how long an implied warranty lasts, or do not
allow exclusion or limitation of incidental or consequential damages, so these limitations may not
apply to you.
To obtain service under this warranty, you must:
1.Send written notice of the claimed condition to: The Outdoor GreatRoom Company, 2015
Silver Bell Road, #195, Eagan, MN 55122.
2.Affirm that you are the original owner of the Product.
3.Provide The Outdoor GreatRoom Company reasonable opportunity to investigate the claim,
including reasonable opportunity to inspect the Product prior to any repair or replacement work
and before the Product or any component of the Product has been removed.
The Outdoor GreatRoom Company
Outdoor Products Limited Warranty