Overland Storage NEO XL Series Manual

10400672-001 ©2015 Overland Storage, Inc. Page 1 of 2
*10400672001*
NEO®XL-Series
Setup Instructions
This document describes how to install the drive power boards
and power supplies to make your NEOxl 80 or NEOxl
Expansion ready for service.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
WARNUNG: Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Install Power Supplies
Remove the Cover Plate
1. At the rear, with your fingers, loosen the three Phillips
screws on the power supply cover.
2. Using the thumbscrews (one on each side), pull the plate
off and set it aside.
Install the Power Supply
1. Position the new power supply onto the alignment rails
and slide the power supply into the library until it is
flush with the back panel of the library.
2. Tighten the blue captive thumbscrews with your
fingers to secure it to the library.

10400672-001 ©2015 Overland Storage, Inc. Page 2 of 2
http://support.overlandstorage.com
You can get additional technical support on the Internet at the Overland Storage Support web page, or by contacting Overland Storage using
the information found on the Contact Us page on our web site.
Setup Instructions
Install Drive Power Boards
NOTE: The NEOxl 80 has one drive power board to install; the
NEOxl Expansion has two drive power boards.
Remove the Chassis Fan
1. Loosen the two blue captive thumbscrews on the
chassis fan assembly.
2. Using the thumbscrews, slowly remove the chassis fan
assembly from the library and set it aside.
Install the Boards
1. Position a drive power board onto the alignment rails
and slide the drive power board into the library until
seated firmly.
2. Push the latch up until it snaps into place.
When the drive power board is installed correctly, the
latch will be tight.
3. For the NEOxl Expansion, repeat Steps 1–2 for the
remaining drive power board.
Reinstall the Chassis Fan
1. Align the tabs on the library with the slots at the top of
the chassis fan assembly.
2. Push in the chassis fan assembly until it is flush with
the back panel of the library.
3. Tighten the blue captive thumbscrews with your
fingers to secure it to the library.