List of figures
Fig. 1: Disconnect device in accordance with EN 61010-1 11
Fig. 2: Front panel 19
Fig. 3: Connections on the rear side 19
Fig. 4: Display CenterOne 20
Fig. 5: Display CenterTwo and CenterThree 20
Fig. 6: Exponential illustration of the measurement channel measured value (exam-
ples)
20
Fig. 7: Parameter or bar graph 21
Fig. 8: Switch-points, parameter mode and input lock 21
Fig. 9: Measurement channel status 21
Fig. 10: Mains connection with IEC 320 C13 socket 22
Fig. 11: Connections A and B on the measuring channels 23
Fig. 12: Connection CH A (RJ-45 socket) 23
Fig. 13: Connection CH B (D-Sub socket) 24
Fig. 14: "CONTROL" connection (15-pole D-Sub plug) 24
Fig. 15: "CONTROL" connection (9-pole D-Sub plug) 25
Fig. 16: "RELAY" connection (25-pole D-Sub socket) 26
Fig. 17: "USB" connection (type B) 26
Fig. 18: "USB" connection (type A) 27
Fig. 19: "Ethernet" (LAN) connection 27
Fig. 20: Guide rails 28
Fig. 21: Rack module adapter (2 height units, only CenterOne) 28
Fig. 22: Rack module adapter (3 height units) 28
Fig. 23: Adapter plate (only CenterOne with 3 height unit rack module adapter) 29
Fig. 24: Installing the CenterOne 29
Fig. 25: Install CenterTwo/CenterThree 29
Fig. 26: Required control panel cut-out (CenterOne) 30
Fig. 27: Required control panel cut-out (CenterTwo/CenterThree) 30
Fig. 28: Fastening the rubber feet and rubber strip 31
Fig. 29: USB Update Tool 33
Fig. 30: Ethernet Configuration Tool 36
Fig. 31: Changing the measurement channel (only CenterTwo and CenterThree) 39
Fig. 32: Switching gauges on and off 39
Fig. 33: Switching emission on and off 39
Fig. 34: Measuring range 40
Fig. 35: Identifying the gauge 40
Fig. 36: Change from measuring mode to parameter mode 40
Fig. 37: Change parameters 41
Fig. 38: Read/write parameter groups and parameters (CenterOne) 41
Fig. 39: Read/write parameter groups and parameters (CenterTwo/CenterThree) 42
Fig. 40: Switching functions and threshold values 44
Fig. 41: Fast, normal and slow (from left to right) 45
Fig. 42: Press the arrow keys simultaneously > 2 seconds 52
Fig. 43: Program memory test 54
Fig. 44: Parameter memory test 54
Fig. 45: Display test 54
Fig. 46: Test of relays in the device 55
Fig. 47: Start/stop measured data recording 56
Fig. 48: Delete files 56
Fig. 49: Formatting the USB memory stick 57
Fig. 50: Delete parameter files from the USB memory stick 58
Fig. 51: Dimensions CenterOne (in mm) 72
Fig. 52: Dimensions CenterTwo and CenterThree (in mm) 72
List of figures
6/76
