Razor E90 Series Use and care manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Flat screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the five (5) screws
from the side with the power switch.
Pull the cover off. Be careful not to damage the wires for
the charger port and power switch. Set cover aside.
POWER CORE E90 SPRINT POWER SWITCH
REPLACEMENT PROCEDURES
PART # W13111401101

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Disconnect all three (3) wires on the back of the power
switch. Remember the position of the wires, black wire
from charger port connects to gold colored prong, blue
wire connects to middle prong and red wire connects to
side silver prong.
Using a flat screwdriver, remove the glue on the back
of the power switch and push the switch out from the
battery cover.
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.