Razor Cruiser User manual

Owner’s Manual
A-Type, Cruiser & ProModelTM Scooters
NOTE: Manual illustrations are for demonstration purposes only. Illustrations
may not reflect exact appearance of actual product. Specifications subject to
change without notice.
Read and understand this entire manual before
allowing child to use this product!
For assistance contact Razor. DO NOT RETURN TO STORE.

AN IMPORTANT MESSAGE TO PARENTS: This manual contains
important information. For your child’s safety, it is your responsibility to
review this information with your child and make sure that your child
understands all warnings, cautions, instructions and safety topics. Razor
USA recommends that you periodically review and reinforce the information
in this manual with younger riders and that you are required to inspect and
maintain your child’s scooter to insure their safety.
GENERAL WARNING: Scooter riding can be a hazardous activity.
Scooters can, and are intended to move and it is therefore possible to get
into dangerous situations and/or lose control and/or fall. If such things
occur you can be seriously injured or die. LIKE ANY OTHER MOVING
PRODUCT, USING A SCOOTER CAN BE A DANGEROUS ACTIVITY AND MAY
RESULT IN INJURY OR DEATH EVEN WHEN USED WITH PROPER SAFETY
PRECAUTIONS. USE AT YOUR OWN RISK AND USE COMMON SENSE.
•Alwayswearsafetyequipmentsuchashelmet,kneepadsandelbow
pads. Always wear a helmet when riding your scooter and keep the
chinstrap securely buckled.
•Alwayswearshoes.
•Rideonsmooth,pavedsurfacesawayfrommotorvehicles.
•Avoidsharpbumps,drainagegrates,andsuddensurfacechanges.
Scooter may suddenly stop.
•Avoidstreetsandsurfaceswithwater,sand,gravel,dirt,leaves,and
other debris. Wet weather impairs traction, braking, and visibility.
•Donotrideatnight.
•Brakewillgethotfromcontinuoususe.Donottouchafterbraking.
•Avoidexcessivespeedassociatedwithdownhillrides.
•Adultsmustassistchildrenintheinitialadjustmentprocedurestounfold
scooter, adjust handlebar and steering to height, and finally to fold
scooter.
•Obeyalllocaltrafcandscooteringlawsandregulations.
•Watchoutforpedestrians.
•Donotexceed143pounds(65kilograms)totalweightontheA,A2,A3,
AWscooters.220pounds(100kilograms)ontheProModeland175
pounds(79kilograms)ontheCruiserscooter.
•Donotallowchildrenunderageve(5)tousethescooter.ProModel
scootersareforchildrenagessix(6)andabove.Childrenunderage
eight(8)shouldridewithadultsupervisionatalltimes.Allchildrenand
preteens should ride with adult guidance at all times.
•Riderweightdoesnotnecessarilymeanachild’ssizeisappropriatetot
or maintain control of the scooter.
•Aparent’sdecisiontoallowhisorherchildtoridethisproductshouldbe
based on the child’s maturity, skill and ability.
ACCEPTABLE RIDING PRACTICES AND CONDITIONS
Direct parental supervision is required. Scooters are meant to be used only
in controlled environments free of potential traffic hazards and not on public
streets. Do not allow your child to ride a scooter in any areas where vehicle
traffic is present. Child must maintain a hold on the handlebars at all times.
Never allow more than one child at a time to ride a scooter. Never use near
steps, sloped driveways, hills, roadways, alleys or swimming pool areas.
Keep fingers and other body parts away from the product when folding or
unfolding. Adults must not allow children to assist in folding or unfolding the
scooter.
Do not ride a scooter in wet weather. Scooters are intended for use on solid,
flat, clean and dry surfaces such as pavement or level ground without loose
debris such as rocks or gravel. Wet, slick or uneven and rough surfaces may
impair traction and contribute to possible accidents. Do not ride a scooter in
mud,ice,puddlesorwater.Avoidexcessivespeedsthatcanbeassociated
with downhill rides. Never risk damaging surfaces such as carpet or flooring
by use of a scooter indoors. Do not ride at night or when visibility is impaired.
PROPER RIDING ATTIRE
Always ensure child is wearing proper protective equipment such as an
approved safety helmet. A helmet may be legally required by local law
or regulation in your area. A child should always wear shoes, never ride
barefooted or in sandals, and keep shoelaces tied and out of the way of
the wheels.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS
FURTHER INCREASES RISK OF SERIOUS INJURY. USE AT YOUR OWN RISK
AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION.
USE CAUTION.
WARNING: ALWAYS INSPECT SCOOTER PRIOR TO RIDING. Properly
inspecting and maintaining your scooter can reduce the risk of injury. Always
inspect your scooter before riding and regularly maintain it.
WARNING: CHECK LOCAL LAWS REGARDING SCOOTER USE. Check
local laws and regulations to see where and how you may use your Razor
scooter legally. In many states and local areas scooter riders are required
BY LAW to wear a helmet. Check local laws and regulations regarding laws
governing helmet use and scooter operation in your area.
SAFETY WARNINGS

Removecontentsfrombox.Inspectthecontentsoftheboxforscratchesinthepaintand/ordentsthatmayhave
occurred during shipping. Because your scooter was assembled and packed at the factory, there should not be any
problems,eveniftheboxhasafew
scars or dents.
BEFORE YOU BEGIN
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
q Required Tools
5mm
Allen wrench
Grip
Handlebar
Steering tube quick-release
Steering tube/steering column
Joint lever/pivoting mechanism
Rear fender/brake
T-tube
Collar clamp
Front fork
Wheels
Deck
Steering column adjusting screw
2With the front wheel pointed
straight ahead and the handle-
bars square to the front wheel,
tighten the clamp as shown.
Tighten securely.
ASSEMBLY INSTRUCTIONS (PRO MODELTM ONLY)
1Loosen the collar clamp and
slide it upward. With a clock-wise
twisting motion, push and “thread”
theextensiontubeontothefork
until it bottoms out on the fork
headset lock nut.
WARNING: Failure to
properly install and tighten the
collar clamp may cause the rider to
lose control and fall. If you do not
understand these instructions or
the concept of “tighten securely”
seek the assistance of a qualified
mechanic.

WARNING: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-tube.
2Make certain BOTH handlebars
are properly locked onto the T-bar.
1Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and
inserting them into the T-tube.
SET UP AND USAGE INSTRUCTIONS (ALL SCOOTERS)
3To release the folding
mechanism, put one foot on the
deck plate and push joint release
lever down. Raise handlebars up
until securely locked in the upright
position.
Note: The Joint lever is spring-
loaded and will automatically lock
in the upright position when fully
upright.
WARNING: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
Note: The tension of the quick-
release lever can be adjusted by
tightening or loosening the allen
bolt. Be careful not to over-tighten.
You should always be able to open
and close the quick-release lever
by hand and the T-tube should slide
freely with the quick-release open.
q Unfolding the scooter for first time use.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-tube to
telescope up or down while riding
which may cause you to lose
control and fall.
4To adjust the height of the handlebars, open the quick-release lever and
slide the T-bar to the desired position and resecure the quick release lever to
lockintoplace.IftheT-barisraisedtothemaximumheight,depressthepush
button located directly below the quick release lever to lower the T-bar.

WARNING: Failure to
properly secure the quick-release
lever may cause the T-tube to
telescope up or down while riding
which may cause you to lose
control and fall.
Usinga5mmallenwrench,checkthatthecollarclampboltistightenedsecurely.Thisitemistightenedandquality
inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt
to loosen.
CHECK BEFORE RIDING
q Collar Clamp
Usinga3mmallenwrenchandwiththescooterintheuprightandlockedposition,adjustthesetscrewatthebase-
board until there is no free-play between the baseboard and the steering column. Be careful not to over-tighten this
screw as it needs only be snug against the steering column. Verify the adjustment by releasing the steering column
from the locked position and folding the scooter. The locking lever should not bind and the folding movement should be
smooth. The spring-loaded mechanism should automatically lock and be fully seated in the upright position.
q Baseboard/Steering Column Adjusting Screw
q Wheels and Bearings
Under normal circumstances and conditions, Razor wheels and wheel bearings are maintenance free. Nonetheless, it
istheresponsibilityoftheownerorguardiantoperiodicallyinspectthewheelsforwearandtear,theaxleforproper
tightness and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an
indicationofexcesswearandreplacementisnecessary.ReplaceimmediatelywithonlygenuineRazorwheels.Worn
wheels/bearings are considered normal wear-and-tear and are not covered by the Razor Warranty. Wheels other than
genuine Razor wheels may not be compatible with your Razor scooter. The use of anything other than genuine Razor
replacement parts may affect your safety and will void your warranty.
q Cleaning Your Scooter
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the
surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic
components or soften the decals or decal adhesive.
q How to Ride
Place one foot on the baseboard, push forward with the other foot. Steer. For enhanced cornering, lean slightly into the
direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Razor recommends that
you practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor
around others.
WARNING: Wheelies
and other stunt-type riding reduces
your ability to maneuver and control
your scooter. Take the necessary
precautions, such as wearing
appropriate protective gear and
practice in a area safe for stunt
riding and free from obstructions.
WARNING: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter.

Be Careful!
You will see people on TV and maybe even people you know doing
tricks and stunts. These are people who have been practicing on
scooters for a very long time. Don’t try something until you are
ready. Avoid steep inclines and don’t ride too fast — you can lose
control and fall. Skateboard parks are not designed for scooters.
Never ride in traffic or on the street and watch your surroundings
for pedestrians, bikers, boarders and skaters.
Razor Limited Warranty
The manufacturer warranties this product to be free of manufacturing defects
foraperiodof6monthsfromdateofpurchase.ThisLimitedWarrantydoes
not cover normal wear and tear, or any damage, failure or loss caused by
improper assembly, maintenance, or storage.
This Limited Warranty will be void if the product is ever
•usedinamannerotherthanforrecreation;
•modiedinanyway;
•rented.
The manufacturer is not liable for incidental or consequential loss or damage
due directly or indirectly to the use of this product.
WARRANTY
Razordoesnotofferanextendedwarranty.Ifyouhavepurchasedan
extendedwarranty,itmustbehonoredbythestoreatwhichitwas
purchased.
For your records, save your original sales receipt with this manual.
Loose Parts
Check and secure all fasteners before every ride. Make sure the
collar clamp, quick release lever, and handlebar spring buttons are
locked properly in place before riding.
Safety Gear
Always wear proper protective equipment such as an approved
safety helmet, elbow pads and kneepads. Always wear shoes
(lace-upwithrubbersoles),neverridebarefootedorinsandals,
and keep shoelaces tied and out of the way of the wheels.
SAFETY REMINDERS
qq
PRE-RIDE CHECKLIST
DO NOT RETURN TO STORE
Failure to follow these instructions may damage
your product and void your warranty.
q
RAZOR MISCELLANEOUS MISCELLANEOUS