Razor W13113290048 User manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Two (2) 19 mm wrenches
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove six (6) screws from
the deck. Remove the deck from the unit and set aside.
Locate and disconnect the motor connectors from the
controller.
C25 & C25 SLA
REAR WHEEL / MOTOR REPLACEMENT
PART # W13113290048

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 5
Step 3 Step 4
Reverse the steps.
• Reposition the deck and attach with the screws that were removed in Step 1.
ATTENTION: Charge battery 8 hours before using.
Using a Phillps screwdriver remove two (2) screws on
each side from the axle lock nut cover.
Using two (2) 19 mm wrenches, loosen the lock nuts from
the axle. Slide the wheel down and pull the wires from the
battery compartment.