Regency LRT4724 User manual

Parts:
Quantity: 1
G: Thumb
Screws
D: 4-Hole Flat Bracket
C: Back Panel
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Keep all hardware parts and packaging out of reach of children.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
B: Leg
Legacy Return Shell • LRT4724 • INSTRUCTIONS
Organize your parts. You may need a rubber mallet.
E: Corner Bracket
Hardware:
Quantity: 1
Quantity: 1
Quantity: 1
Quantity: 1
Quantity: 10
Quantity: 1
A: Return Top
F: 2-Hole Flat Bracket
C
B
A

STEP 2: Attach Leg (B) to the underside of the Return
Top (A) by lining up the Eclip with its corresponding
holes, and sliding into place . While sliding over, line up
Pins with corresponding holes in Back Panel (C) and
press into place.
STEP 3: Using two people, ip over your assembled
Return, and line it up with your assembled Desk Shell.
STEP 1: Attach Back Panel (C) to the underside of the Return Top (A) by lining up the Eclip with its corresponding holes,
and sliding into place (see gure 1).
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Figure 1
Legacy Return Shell • LRT4724 • INSTRUCTIONS
Organize your parts. You may need a rubber mallet.
C
C
A
A
A
B
C
Underside
Right SideLeft Side
SPECIAL NOTE: Return is reversible. In Step 2, attach
Leg (B) on left side of Return Top (A) for Right Return.
Or, attach on right side of Return Top (A) for Left Return.
Return Shell
Desk Shell
Note: Right Return shown.

STEP 6: Under the desk, where the Back Panel (C)
meets your Desk Leg. Attach 2-Hole Flat Bracket (F)
using 2 Thumb Screws (G). Insert Thumb Screws (G)
through the 2-Hole Flat Bracket (F) and into the predrilled
holes.
STEP 4: Attach Corner Bracket (E) to the underside
of the your desk, where the Return Top (A) and Back
Panel (C) meet your Desk Top and Desk Leg. Attach
by placing 4 Thumb Screws (G) through the Corner
Bracket (E) and into the predrilled holes.
STEP 5: Place 4-Hole Flat Bracket (D) to the underside
of where Return Top (A) meets the Desk Top. Attach
4-Hole Flat Bracket (D) by inserting 4 Thumb Screws
(G) through the 4-Hole Flat Bracket (D) and into the
predrilled holes.
Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Legacy Return Shell • LRT4724 • INSTRUCTIONS
Organize your parts. You may need a rubber mallet.
E
F
C
A
Desk Top
Desk Top
Desk Leg
Desk Leg
A
D
G
G
G
G
G
C
Note: Right Return shown.