Regency BCTRC12048 User manual

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
STEP 1a : Attach Bottom Stringer(I) to Leg(G1)
by inserting Rod into corresponding hole.
STEP 1b : Secure Bottom Stringer(I) to
Leg(G1) with 2 Long Bolts(C) using Assembly
Key(A).
G1
J
BCTRC12048 • INSTRUCTIONS
C
You will need 2 person(s) for this assembly.
D
ABE
F
Hardware: A: Assembly Key B: Dowel Rod(4) C: Long Bolt(6)
D: Short Bolt(20) E: Locking Washer(20) F: Washer(20)
Parts: G: Leg(2) H: Table Top(2) I: Bottom Stringer
J: Top Stringer K: Support(2)
G1 H1 H2
I
J
K
NOTE: Dowel Rod hole
for Top Stringer(J) is
below Long Bolt hole.
G1
I
C
G1
I
STEP 2a : Attach Top Stringer(J) by inserting
Rod(B) into corresponding hole on same Leg(G1)
as Bottom Stringer(I).
STEP 2b : Secure Top Stringer(J) to Leg(G1) with
Long Bolt(C) using Assembly Key(A).
STEP 2c : Repeat Step1a-2b for other Leg(G2).
J
G1
C
G2
All manuals and user guides at all-guides.com

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
BCTRC12048 • INSTRUCTIONS
CYou will need 2 person(s) for this assembly.
Figure 1
NOTE: Short Bolt(D)
with Locking Washer(E)
STEP 3a : Connect Table Top(H1) to Table Top(H2). Fasten Sash Lock (Figure 1).
STEP 3b : Reinforce Table Top(G1,G2) by attaching 2 Supports(K) with 4 Short Bolts(D) and 4 Locking
Washers(E) in each Support using Assembly Key(A).
STEP 4 : Finish by attaching Table Top(H1,H2) to Legs(G1,G2) with 3 Short Bolts(D), 3 Washers(F) and 3
Locking Washer(E) for each Leg Corner.
NOTE: Short Bolt(D)
with Washer(F) and
Locking Washer(E)
K
All manuals and user guides at all-guides.com