Regency TTRC4824 User manual

A BC DEFGA. Table Top
B. Rod
C. Cylinder
D. Screws (16)
E. Feet (4)
F. Spider
G. T-base
Rectangle and Corner Training table with T-Base
Step 1: Screw 4 feet (E) into
T-base leg ends (G).
Step 2: On the rod (B) remove
the nut from the bolt, set the nut
aside.
Step 3: Insert the rod (B) through the
hole in the T-base (G).
The permanent
nut should be
on the underside
of (G).
STEP 4: Next place the cylinder
(C) over the exposed metal rod
STEP 5: Place the exposed end of
the metal rod (B) through the hole in
the spider (F) and twist the nut back
onto the rod until tight. Make sure the
front and back arms of the spider are
angled in the same direction as the
T-Base arms.
The product
should now
look like the
example to the
right.
(TTRC4824, TTRC6024, TTRC7224, TTCNR24, MTBT22)
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
Two people are required for assembly.

IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Any problems or questions please call Regency Office Furniture at 1-866-816-9822
STEP 7: Turn Table Upside down.
Draw 2 horizontal lines across the
table bottom, so line 1 is a con-
stant 6.25” inches from the front
and line 2 is a constant 6.25” from
the back. See photo on the right.
STEP 10: Align spider over marks
made in step 8 and drill 8 screws
in per T-base. Flip Table over when
complete.
STEP 11: To attach corner TTCNR24
please follow the instructions on
the back of this page.
Black Dots represent where screws
are placed.
STEP 9: Mark the 4 holes from the template
on the table top. Flip the instructions to the
right side of desk and repeat this step. These
4 marks will be for the left and right arms of
the spider.
1
2
STEP 8: Place Instructions
upside down so the template
can been read in between the
lines to the left edge of the
desk.
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line.

LINE UP TOP EDGE OF SECOND SHEET HERE.

If you are using this template for a corner connector place the dotted line over the junction of the table. Their will be one arm of the spider connected just to the corner table, one connected to just the large training table and the top and bottom arm’s will have screws in both tables to secure the junction. See step 11.
If you are using this template for single table, Align this end of the template in between the lines made in step 7.
TABLE EDGE