Regency TVCTRC12048 User manual

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware, parts and packaging out of reach of children.
Organize your parts and
hardware.
Hardware Components should include:
A) 12 Threaded Cams B) 12 Large Bolts
C) 1 Assembly Key D) 2 Medium Bolts (Type A)
E) 2 Medium Bolts (Type B) F) 8 Lag Bolts
G) 16 Small Bolts
Wooden parts include:
H) 2 Side Legs I) 1 Center Leg
J) 2 Table Top Halves
K) 2 Side Stringers (Type A)
L) 2 Side Stringers (Type B)
M) 1 Center Stringer (Type A)
N) 1 Center Stringer (Type B)
TVCTRC12048 | TVCTRC9648 - INSTRUCTIONS
A
Step 1: Connect two Table Top Halves
(J) together. Align pins. Close Latch to
hold halves together.
Step 2: Insert Threaded Cams (A) into
holes. Holes are located on sides of Side
and Center Stringers. Turn so that the
longer line on the Cam is horizontal.
B
C D E
F G
H I
J KL K L M N
F
B
E
D
G
H I
JA
IMPORTANT: You may want to
position all parts before attaching
with bolts to ensure that assembly
will be completed correctly. All Type
A Stringers should be on the same
side of the table; likewise, the same is
true for Type B Stringers. The Type B
Stringers, when attached should cover
the Bolts used to secure the Type A
Stringers.

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
Step 3: Attach Center
Leg (I) to Table Top with
Small Bolts (G). Do not
tighten completely.
Step 4: Attach Type A Center Stringer
(M) to Center Leg (I). Use Type A
Medium Bolt (D) for top hole, Type B
(E) for bottom. Do not overtighten.
Step 5: Attach Type B Center
Stringer (N) to Center Leg (I). Use
(D) Bolts for top hole, (E) for
bottom. Do not overtighten.
Step 6: Attach Type A Side Stringer (K) to Center Leg (I). Use Large
Bolts (B) to secure. Attach Type B Side Stringer (L) to Center Leg (I)
with Large Bolts (B). Bolts will thread into Cams, but be careful not
to overtighten–Cams may crack wood.
Step 7: Attach Side Legs (H) to
Center Stringer and Side Stringers
with Large Bolts (B). Then secure
Legs to Table Top with Small Bolts
(G). Do not secure to Table Top
completely until all Bolts are in place.
Be sure to tighten all Bolts after
assembly is completed. Do not
overtighten.
Step 8: Insert Lag Bolts
(F) into Side Stringers
and secure to Table Top.
J
II
M
I
INM
I
K
I
KILI
K
H