RIGHT ANGLE NewHeights Gas Lift Adjustable SkateDesk User manual

NewHeights™ Gas Lift Adjustable
SkateDesk Instructions
Instruction #54466 • Dated: 1/27/2021 1 of 3

K&A Manufacturing • 800.298.4351 • www.raproducts.com/install 2 of 3
NewHeights SkateDesk Instructions #54466
Tools Required for Assembly
A. Power Driver with Adjustable Torque
B. #2 Phillips Head Driver Bit
C. #2 Square Head Drive Bit (Recommended)
May alternately use a #2 Phllips
or #2 Square Screwdriver
A B C
D. 5/8” Washer Head Wood Screw x8
E. Levelers x2
Hardware and Tools Included for Assembly (may have extra)
D
• Place worksurface on a protected surface with pilot
holes facing up. Align base with worksurface pilot
holes as shown. Install (8) washer head wood screws.
AD
May alternately use a #2 Phllips or #2 Square Screwdriver
Assembling Adjusting Height
Press and hold lever
to adjust height
Levelers must be extended partially;
to level the worksurface
Tools Required for Assembly
E

K&A Manufacturing • 800.298.4351 • www.raproducts.com/install 3 of 3
NewHeights SkateDesk Instructions #54466
• Remove nut, wheel, washer, and bolt
• Install leveler included in hardware bag into
threaded hole
• Repeat on opposite side
• Store wheels and hardware
• Remove levelers
• Store levelers for future use
• Install bolt through outside leg hole, then
install washer, wheel, and nut. Wheels
install on the inside of the base. Tighten
but make sure wheel still rotates freely.
• Repeat on opposite side
Rolling to Stationary Stationary to Rolling
Converting