RIGHT ANGLE NewHeights Laminate Footshelf User manual

www.raproducts.com
Page1 OF 3
Read all the instructions before beginning.
K&A Manufacturing
Instruction # 53405
3/26/15
6703 Zinser Street
Schofield, WI 54476
Phone: [phone]
Fax: [phone]
NewHeights™ Laminate Footshelf
Assembly Instructions

Page 2 OF 3
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
Tools Required for Assembly:
Power Driver W/Adjustable Torque
#2 Phillips Head Driver Bit or
#2 Square Head Driver Bit
3/16" Hex Head Driver Bit or
Allen Wrench
Hardware Is Drawn Actual Size
53099 53025 53024 51708
ITEM # PA T # DESC IPTION QTY.
1 53099 5/16-20 Offset Weld Nut 4
2 53025 5/16 Lock Washer 4
3 53024 5/16-18 x 1/2 Button Head Socket Screw 4
4 51708 M5 x 18mm (7/8") Sq/Ph/Wshr Head Wood Screw Varies
5 Varies NewHeights Footshelf Bracket 2
6 Varies 3/4" Laminate Footshelf 1
Step 1: Assemble the workstation completely. If your
unit has a cross support, do not attach it at this time.
Raise the workstation to its highest level. Remove
the outer column covers from the tops of the outer leg
extrusions and raise them to the tops of the inner leg
extrusions. If your workstation has a cross support,
remove the 4" centerline weld nuts from the grooves
in the back of the leg assemblies. Drop (1) weld nut 1
into each groove in the front and back of the outer leg
extrusions. See Detail A. Replace the 4" centerline
weld nuts. Install the cross support.
Instruction # 53405
12 3 4
Step 1
A
DETAIL A
4" Centerline Weld Nut
1

Step 3
Page 3 OF 3
K&A Manufacturing
(fron the top) on the low corners of the unit.
Phone: [phone]
6703 Zinser Street Schofield, WI 54476
www.raproducts.com
Fax: [phone]
Step 2: Lower the worksurface to its lowest position.
Place (4) lock washers 2 on (4) socket screws 3 .
Insert these through the holes on the longer sides of the
footshelf brackets 5 and thread them into the weld nuts
1 you inserted into the grooves in step 1. Fully tighten
the socket screws.
Step 3: With the help of an assistant, lay the work-
station on its back on a protected surface. Attach the
footsheld to the brackets with (10-12) wood screws 4
through the holes in the brackets 5 and into the pilot
holes in the bottom of the footshelf. Stand the work-
station upright in its final position and level it if
by required by turning the leveling glides clockwise
Instruction # 53405
5
2
3
Step 2
4