RIGHT ANGLE R-Style Tango User manual

Instruction #54648 • Dated: 01/25/2022 1 of 4
R-Style™Tango Assembly Instructions
Warranty: raproducts.com/warranty

K&A Manufacturing • 800.298.4351 • www.raproducts.com/install 2 of 4
D. 5/8” Round Washer Head Wood Screw x40
*Desks 48” or smaller only receive 28 screws
Tools Required for Assembly
A. Power Driver with Adjustable Torque
B. #2 Square Head Drive Bit
C. Level
A B C
Hardware and Tools Included for Assembly (may have extra)
D
E. Post Leg x4
F. U-Channel x2
*Desks 48” or smaller will NOT include U-Channel
Tango Parts
EF

K&A Manufacturing • 800.298.4351 • www.raproducts.com/install 3 of 4
Step 1
D
F
Step 2
A DB
• Lay worksurface on a protected surface with
the pilot holes facing up.
*The following does NOT apply to desks
sized 48” or smaller.
• Align U-Channel (F) with the pre-drilled pilot
holes along the center of the worksurface.
• Attach U-Channel to the worksurface with 5/8”
round washer head wood screws (D).
• Do NOT fully tighten until all screws are
installed.
A DB
• Align one of the post legs (E) with the predrilled
pilot holes.
• Attach the leg to the worksurface with 5/8”
round washer head wood screws (D).
• Do NOT fully tighten until all screws are
installed.
• Repeat to attach remaining 3 legs.
E
D

K&A Manufacturing • 800.298.4351 • www.raproducts.com/install 4 of 4
Step 3
• Carefully flip the table over to stand it rightside up.
• Place the level (C) on the worksurface.
• Level the table by turning the levelers (located at
the bottom of the table legs) clockwise or counter-
clockwise. Reference your level (C) to identify when
the table is properly leveled.
• Reference your level (C) to identify when the table
is properly leveled.
C