Saxby Lighting Sight Plus 72638 Manual

Instruction leaflet
Sight Plus
72638
Recessed Accessory

This accessory is suitable for use with the Sight Plus LED Wall Light(72636/72637) and allows the products to
have a lower profile when installed.
For electrical safety information, please refer to the original Sight Plus instruction manual.
1. Cut a hole in the ceiling using an appropriate tool. The cut out dimensions are 352 x 100mm and the
minimum ceiling void depth is 100mm. It is recommended to cut the hole slightly smaller than needed, then
file the hole until the recessed unit fits snugly. The ceiling surface must be flat and smooth to ensure a
good fit.
2. Fit the spring clips to the 4 corners of the recessed accessory, as shown in the below drawings.
3. Undo the two screws on the front of the Sight Plus light unit. Remove the screws and cover and set aside.
4. Unclip the front panel by pushing the quick release tabs to expose back casing.
5. Drill out the two holes on the back casing which align with the holes on the recessed accessory. The holes
on the back of the Sight Plus light unit are located in the centre of the two triangle marks.
6. Using the 2 x screws and 2 x nuts supplied, fix the product to the accessory and tighten to secure.
7. Wire as detailed in previous Sight Plus product instruction manual and refit front panel set aside earlier.
8. Push the spring clips upwards and fit into the ceiling hole.
9. Push the unit up until firmly in position, ensuring that no cables are trapped.
10. Ensure that the product is sitting properly in the hole.
11. Product is ready for use.
www.saxbylighting.com
Saxby Lighting Ltd. BH23 3PE
Iss 1 22052017
156
99